IKEA ÄPPLARÖ 102.051.81 Bench instructions manual

The IKEA ÄPPLARÖ 102.051.81 is an outdoor bench designed for durability and comfort, featuring a solid acacia wood frame and weather-resistant construction. Suitable for patios, gardens, and decks. Below are key sections for safety, parts list, assembly instructions, care, and warranty information.

1. Parts & Hardware Included 2. Tools Required 3. Safety Instructions 4. Step-by-Step Assembly 5. Care & Maintenance 6. Specifications 7. Warranty Information 8. Troubleshooting

Parts & Hardware Included

Before assembly, verify all parts are present. Contact IKEA if any items are missing.

Part DescriptionQuantityImage Reference
Bench Seat (Acacia wood)1A
Bench Legs (Left & Right)2B
Support Beams (Crossbars)2C
Wood Screws (6x50 mm)12D
Allen Key (5 mm)1E
Assembly Instructions1 set-

Tools Required

Only the provided Allen key is needed. A Phillips screwdriver may be helpful but is not required.

Safety Instructions

WARNING! Read all instructions before assembly. Failure to follow may result in injury or damage.

  1. Assemble on a soft, clean surface to avoid scratching wood.
  2. Use two people for handling larger parts to prevent strain or dropping.
  3. Ensure all screws are tightened securely to ensure stability.
  4. Keep small hardware away from children to avoid choking hazards.
  5. Check bench stability on a level surface before use.

CAUTION! Do not exceed the maximum weight capacity of 330 lbs (150 kg) distributed evenly.

Step-by-Step Assembly

Estimated assembly time: 30-45 minutes. Follow steps in order.

  1. Step 1: Lay the bench seat (Part A) upside down on a protected surface.
  2. Step 2: Attach the left leg (Part B) to the underside of the seat using 4 wood screws (Part D). Do not fully tighten yet.
  3. Step 3: Repeat Step 2 for the right leg.
  4. Step 4: Position the two support beams (Part C) between the legs, aligning pre-drilled holes. Secure each beam with 2 screws per side.
  5. Step 5: Once all parts are aligned, fully tighten all screws using the Allen key. Ensure no screws are protruding.
  6. Step 6: Carefully turn the bench upright. Test stability by applying gentle pressure.

TIP: If parts do not align easily, loosen adjacent screws slightly, adjust, then retighten.

Care & Maintenance

Proper care extends the life of your ÄPPLARÖ bench.

CAUTION! Never use bleach or solvents, as they can damage the wood finish.

Specifications

Warranty Information

IKEA Limited Warranty: This product is covered by a 10-year limited warranty against manufacturing defects under normal residential outdoor use. Warranty does not cover damage from improper assembly, accidents, neglect, or commercial use. Proof of purchase is required.

For warranty claims, contact IKEA Customer Service at 1-888-888-4532 or visit www.ikea-usa.com.

Troubleshooting

IssuePossible CauseSolution
Bench wobblesUneven surface or loose screwsPlace on level ground; check and tighten all screws.
Wood cracking/splittingOver-tightening screws or impactDo not over-tighten; avoid dropping. Contact IKEA if part is defective.
Screws not aligningParts misaligned during assemblyLoosen nearby screws, align parts correctly, then retighten.
Discoloration or moldMoisture trapped, lack of ventilationClean with mild soap, dry thoroughly. Apply wood protector annually.
Missing part/hardwarePackage incompleteRefer to Parts List. Contact IKEA with product number (102.051.81) for replacement.

For Support: Visit www.ikea-usa.com or call 1-888-888-4532. Have product name (ÄPPLARÖ) and article number (102.051.81) ready.

IKEA ÄPPLARÖ 102.051.81 Bench instructions manual © - All Rights Reserved 2025