IKEA VOXTORP 193.774.46 Corner Cabinet instructions manual

The IKEA VOXTORP 193.774.46 is a corner cabinet designed for kitchen use, featuring a modern design with adjustable shelves, soft-closing hinges, and a sturdy construction. This manual provides essential information for safe assembly, installation, use, and maintenance of your corner cabinet. Below are key sections covering safety, parts identification, step-by-step assembly, installation, adjustment, care, and troubleshooting.

1. Parts & Hardware Included 2. Safety Instructions 3. Assembly Instructions 4. Installation & Leveling 5. Adjusting Doors & Shelves 6. Care & Cleaning 7. Troubleshooting 8. Specifications & Warranty

Parts & Hardware Included

Before assembly, verify all parts are present. Key components: Cabinet frame panels, adjustable shelves, door(s), hinges, screws, dowels, cam locks, and mounting brackets.

Part Description	Quantity	Identification Code
Cabinet side panel (left)	1	A
Cabinet side panel (right)	1	B
Cabinet back panel	1	C
Cabinet top panel	1	D
Cabinet bottom panel	1	E
Adjustable shelf	2	F
Door panel	1	G
Soft-closing hinge set	2	H
Cam lock screws	10	I
Mounting brackets	2	J

Safety Instructions

Read all instructions before assembly. Use proper tools.

Work Area: Assemble on a clean, flat, protected surface.
Lifting: Cabinet is heavy; use two people for lifting and positioning.
Secure Assembly: Tighten all screws and fittings securely but do not overtighten.
Wall Mounting: MUST be securely attached to wall studs using provided brackets to prevent tipping.
Children: Keep children away during assembly. Do not allow climbing on installed cabinet.

WARNING! Failure to secure cabinet to wall can result in serious injury or death from tipping.

Assembly Instructions

Follow steps in order. Use included Allen key.

Step 1: Lay side panels (A & B) flat. Insert dowels into pre-drilled holes.
Step 2: Attach bottom panel (E) to side panels using cam locks (I). Tighten with screwdriver.
Step 3: Attach top panel (D) in same manner as bottom.
Step 4: Attach back panel (C) using screws provided. Ensure cabinet is square.
Step 5: Insert shelf supports at desired heights. Place adjustable shelves (F) on supports.
Step 6: Attach hinges (H) to door (G) according to diagram. Then attach door to cabinet frame.

Tip: Do not fully tighten hinges until door alignment is adjusted after installation.

Installation & Leveling

Cabinet must be installed level and secured to wall.

Position assembled cabinet in corner. Ensure it is level front-to-back and side-to-side using a spirit level.
Mark wall stud locations through mounting bracket holes.
Drill pilot holes into wall studs. Attach cabinet firmly to wall using mounting brackets (J) and suitable wood screws (not included for masonry walls).
Re-check level after securing. Adjust by placing shims behind brackets if necessary.

CAUTION! Use appropriate wall anchors if not attaching directly to studs. Cabinet must support its own weight plus contents.

Adjusting Doors & Shelves

Door Adjustment: Use hinge screws for fine-tuning.

Height: Loosen hinge screws attached to cabinet, move door up/down, retighten.
Depth: Adjust screw on hinge side to move door closer to or farther from frame.
Side-to-Side: Adjust screw on hinge arm to align door evenly with frame.

Shelf Adjustment: Shelf supports are removable. Lift shelf slightly to remove. Reposition supports in desired holes and replace shelf.

Care & Cleaning

Use a soft, damp cloth with mild soap. Wipe dry immediately.

DO NOT USE: Abrasive cleaners, scouring pads, harsh chemicals, or solvents.

For surfaces: Clean spills promptly to prevent staining.

Troubleshooting

Problem	Possible Cause	Solution
Door does not close properly	Hinge misaligned; cabinet not level	Re-adjust hinges per section 6. Ensure cabinet is level.
Door does not soft-close	Hinge mechanism dirty or defective	Clean hinge pin area. If persists, hinge may need replacement.
Shelf wobbles or sags	Supports not fully seated; overloaded	Ensure supports are clicked into holes. Do not exceed max load (see specs).
Cabinet feels unstable	Not secured to wall; floor uneven	Re-secure to wall studs. Use shims to level base.
Scratches on surface	Abrasive cleaning or impact	Use touch-up pen (available separately) for minor scratches.

Specifications & Warranty

Article Number: 193.774.46
Color: As specified on packaging (e.g., Black-Brown, White).
Dimensions (HxWxD): Approx. 80 x 60 x 60 cm (corner unit).
Max Shelf Load: 15 kg per shelf.
Material: Particleboard, foil, ABS plastic.
Warranty: IKEA limited warranty. See IKEA guarantee for details.
Spare Parts: Available at IKEA stores or www.ikea.com.

Contact: For missing parts or support, visit www.ikea.com or contact your local IKEA store.