IKEA VIHALS 504.887.34 Table instructions manual

The IKEA VIHALS 504.887.34 is a versatile and modern table designed for dining, work, or general use. It features a sturdy construction, clean lines, and is part of the VIHALS series. This manual provides essential information for safe unpacking, assembly, use, care, and troubleshooting of your new table. Below are key sections covering safety, parts list, step-by-step assembly, usage guidelines, maintenance, and support.

1. Safety Information 2. Parts & Tools Included 3. Step-by-Step Assembly 4. Product Specifications 5. Usage & Features 6. Care & Maintenance 7. Disassembly & Moving 8. Warranty Information 9. Troubleshooting

Safety Information

Read all instructions before assembly and use. Keep for future reference.

Warning	Description
Weight Limit	Do not exceed the maximum load capacity of 50 kg (110 lbs).
Assembly Surface	Assemble on a soft, clean surface to avoid scratches.
Tool Use	Use only the included Allen key; do not overtighten screws.
Children	Do not allow children to climb or hang on the table.
Stability	Ensure all legs are firmly attached and the table is level before use.
Heat & Liquids	Use coasters for hot/cold drinks; wipe spills immediately.

Parts & Tools Included

Check that all parts are present before starting assembly.

Tabletop: 1 piece (Material: Particleboard with melamine foil).
Legs: 4 pieces (Material: Steel, powder-coated).
Mounting Brackets: 4 sets (pre-attached to tabletop underside).
Screws: 16 pieces (Type: M6 x 16mm).
Allen Key: 1 piece (Size: 4mm).
Instruction Manual: This document.

IMPORTANT! If any part is missing or damaged, contact IKEA customer service. Do not attempt assembly.

Step-by-Step Assembly

Estimated assembly time: 15-20 minutes. Requires 1 person.

Prepare: Unpack all parts. Place the tabletop upside down on a soft, protected surface (e.g., carpet or blanket).
Attach Legs: Align one leg with a mounting bracket. Insert 4 screws through the bracket holes into the leg. Tighten firmly with the Allen key, but do not overtighten.
Repeat: Attach the remaining three legs in the same manner.
Check Stability: Carefully turn the table right-side up. Gently rock the table to ensure all legs are secure and the table does not wobble.
Final Inspection: Ensure all screws are tight and the tabletop is level.

CAUTION! Lifting the assembled table requires care due to weight. Use proper lifting technique or ask for assistance.

Product Specifications

Article Number: 504.887.34
Product Name: VIHALS Table
Dimensions (LxWxH): 120 cm x 60 cm x 74 cm (47 1/4" x 23 5/8" x 29 1/8")
Tabletop Thickness: 2.8 cm (1 1/8")
Material: Tabletop: Particleboard, Melamine foil; Legs: Steel, Powder coating
Color: White
Max Load: 50 kg (110 lbs) evenly distributed
Weight (Packaged): Approx. 15 kg (33 lbs)
Package Contents: 1 tabletop, 4 legs, screws, Allen key, instructions

Usage & Features

Designed for indoor use in dining rooms, kitchens, home offices, or living areas.

Features: Smooth, easy-clean surface; Sturdy steel legs; Modern, minimalist design; Scratch-resistant melamine foil.

Usage Tips: - Use as a dining table, desk, or console table. - For writing or computer use, ensure adequate legroom. - Avoid placing near direct heat sources (radiators, fireplaces) or in damp areas. - Do not cut or place hot pots/pans directly on the surface; always use protective mats or trivets.

Care & Maintenance

Proper care will extend the life and appearance of your table.

Cleaning: Wipe with a soft, damp cloth. For stubborn stains, use a mild soap solution. Dry immediately with a clean cloth.
Do NOT use: Abrasive cleaners, scouring pads, solvents (acetone, alcohol), or ammonia-based cleaners.
Protection: Use placemats, coasters, and tablecloths to prevent scratches, heat marks, and water rings.
Inspection: Periodically check and tighten screws if the table becomes loose.

WARNING! Never soak the table or allow liquids to pool, especially at the edges, as this can cause the particleboard to swell.

Disassembly & Moving

To move or store the table, it is recommended to disassemble it.

Turn the table upside down on a protected surface.
Using the Allen key, loosen and remove all screws connecting the legs to the brackets.
Carefully separate the legs from the tabletop.
Store or transport all parts together. Protect the tabletop surface from scratches.
For reassembly, follow the original assembly instructions.

Tip: Place screws in a sealed bag and tape it to the underside of the tabletop to avoid loss.

Warranty Information

This IKEA product is covered by a limited warranty. Refer to the IKEA warranty terms included in the "Guarantee" document in your purchase package or available at www.ikea.com.

Support: For assembly help, spare parts, or other inquiries: - Visit: www.ikea.com - Contact your local IKEA store. - Have your article number (504.887.34) and proof of purchase ready.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Table wobbles	Uneven floor; Loose legs	Check floor level; Tighten all leg screws firmly. If floor is uneven, use furniture pads under the shorter leg(s).
Scratches on surface	Abrasive contact	Prevent further damage with a tablecloth. Minor scratches can sometimes be masked with a matching wax crayon.
White stains (water rings)	Moisture trapped under hot/cold item	Gently rub with a cloth dampened with a mild vinegar solution, then dry. Use coasters to prevent.
Screw won't tighten	Stripped thread; Misalignment	Ensure leg is perfectly aligned with bracket. If thread is stripped, contact IKEA for a replacement screw/bracket.
Tabletop edge swelling	Prolonged exposure to liquid	Dry immediately after spills. Significant swelling may require part replacement; contact IKEA.

Note: For issues not listed, or if damage occurred during assembly due to a possible manufacturing defect, contact IKEA customer service with your article number and receipt.