IKEA UPPFÖRA 194.282.76 Frame instructions manual

The IKEA UPPFÖRA 194.282.76 is a versatile picture frame designed for easy assembly and display of your favorite photos or artwork. It features a clean, modern design, secure glass or acrylic front, sturdy backing, and integrated hanging hardware. Below are key sections for safety, features, assembly, installation, care, and troubleshooting.

1. Features at a Glance 2. Package Contents 3. Assembly Instructions 4. Specifications 5. Mounting & Installation 6. Inserting & Changing Pictures 7. Care & Cleaning 8. Safety Information 9. Warranty & Support 10. Troubleshooting

Features at a Glance

Key components: Frame front (glass/acrylic), Frame back, Mounting brackets or clips, Hanging hardware (sawtooth hanger or wire), Protective corner pads.

FeatureDescription
Frame MaterialSturdy composite wood or metal with finished surface
Front PanelClear glass or shatter-resistant acrylic
BackingRigid cardboard or fiberboard with stand-up kickstand
Mounting SystemEasy-click or screw-fastened corners
Hanging HardwareIntegrated sawtooth hanger or detachable hanging wire
SizeDesigned for standard photo paper or custom matting
Finish OptionsAvailable in black, white, silver, or wood effect
Protective PadsFelt pads for wall protection and stability
Multi-orientationCan be hung vertically or horizontally
Easy-open tabsSpring-loaded tabs for easy picture changes

Package Contents

Unpack and verify all parts before starting assembly.

  1. Frame front with protective film.
  2. Frame back panel.
  3. Set of 4 corner brackets or closure clips.
  4. Hanging hardware (sawtooth hanger or wire with screws).
  5. 4x Protective felt pads for corners.
  6. Instruction manual (this sheet).

WARNING! Check for damaged parts before assembly. Do not use if glass is cracked or chipped.

Assembly Instructions

Work on a clean, soft surface to avoid scratches.

  1. Remove protective film from front glass/acrylic panel.
  2. Place frame front face down on soft cloth.
  3. Insert your photo or artwork into the frame, ensuring it is centered.
  4. Place the backing board over the photo, aligning edges.
  5. Secure the backing using the provided clips or brackets. For clip system: Press clips into slots on frame sides. For screw system: Insert and tighten screws at each corner.
  6. Attach hanging hardware to back as per mounting instructions.
  7. Apply felt pads to bottom corners of frame back.

CAUTION! Handle glass/acrylic with care. Avoid overtightening screws.

Specifications

Mounting & Installation

Choose a suitable wall location. Use appropriate wall anchors for your wall type (drywall, plaster, brick).

For Sawtooth Hanger: Install a single wall hook or nail aligned with the hanger notch.

For Wire Hanger: Install two wall hooks or nails spaced wider than the frame, allowing the wire to hang between them.

  1. Mark wall position with pencil, using a level.
  2. Install wall hooks/nails securely.
  3. Hang frame, ensuring it is level and secure.
  4. For heavy frames or uneven walls, use wall anchors.

Tip: Always mount into wall studs when possible for maximum security.

Inserting & Changing Pictures

Easy-access design allows quick picture updates.

  1. Lay frame face down on soft surface.
  2. Release securing clips or brackets (if screw type, loosen slightly).
  3. Remove backing board carefully.
  4. Replace old picture with new one, ensuring proper orientation.
  5. Replace backing board and re-secure all clips/brackets.
  6. Re-hang frame.

WARNING! Do not force clips. Ensure picture is flat and free of wrinkles.

Care & Cleaning

Remove frame from wall before cleaning.

  1. Use a soft, dry microfiber cloth to dust frame and glass/acrylic.
  2. For smudges, lightly dampen cloth with water or glass cleaner. Do not spray directly on frame.
  3. Wipe gently and dry immediately.
  4. Avoid abrasive cleaners, solvents, or ammonia-based products on frame finish.

CAUTION! Never immerse frame in water. Avoid excessive moisture.

Safety Information

Keep away from direct heat sources, radiators, or open flames. Do not hang in damp areas (e.g., bathrooms) unless specifically rated for moisture. Ensure secure mounting to prevent falling, especially in households with children or pets. Glass fronts can break if dropped or struck - handle with care.

Warranty & Support

IKEA limited warranty applies as per local regulations. For missing parts or assembly support, contact your local IKEA store or visit www.ikea.com. Retain your receipt as proof of purchase.

Troubleshooting

SymptomPossible CauseCorrective Action
Frame won't hang straightUneven wall or hardwareUse a level during installation; ensure hooks are even.
Backing won't stay secureClips not fully engagedPress clips firmly into slots; check for obstructions.
Picture appears crooked inside framePicture not centeredReopen frame and reposition picture before securing.
Glass/acrylic has scratchesImproper cleaning or handlingUse only soft cloths; avoid abrasive materials. Minor scratches may be acceptable.
Frame feels unstable on wallInsufficient wall anchorUse appropriate wall anchors for your wall type; mount into stud if possible.

Replacement Parts: Available at IKEA stores or via customer service.

Support: Visit www.ikea.com or contact your local IKEA store.

IKEA UPPFÖRA 194.282.76 Frame instructions manual © - All Rights Reserved 2025