IKEA TORSBY 292.518.56 Tabletop instructions manual

The IKEA TORSBY 292.518.56 is a rectangular tabletop designed for use with compatible IKEA table legs or frames. Made from particleboard with a durable melamine foil finish, it is scratch-resistant and easy to clean. Below are key sections for safety, assembly, installation, care, and warranty information.

Product Overview

Key features: Rectangular shape, particleboard core, melamine foil surface, pre-drilled mounting holes for legs/frames, rounded edges for safety.

Included Parts

Check package contents upon receipt.

1. Tabletop (1 piece)
2. Mounting hardware (screws, bolts if included with specific product bundle)
3. Instruction manual (this document)

Note: Legs or frames are sold separately unless specified in product bundle.

Safety Instructions

Read all instructions before assembly and use.

1. Use on stable, level surface only.
2. Do not exceed maximum weight capacity (see section 8).
3. Keep away from excessive heat, moisture, or direct sunlight.
4. Assemble with provided or recommended hardware only.
5. Ensure all screws are tightened securely.

WARNING! Tabletop is heavy; lift with care using two people to avoid injury or damage.

Assembly Instructions

General assembly steps for tabletop with legs or frame.

1. Place tabletop upside down on soft, flat surface (e.g., carpet or cardboard) to prevent scratches.
2. Identify pre-drilled mounting holes on underside of tabletop.
3. Align legs or frame with mounting holes.
4. Insert screws through holes in leg/frame bracket into tabletop.
5. Tighten screws securely with screwdriver or Allen key (as provided).
6. Turn tabletop right-side up and place in desired location.

Tip: Do not overtighten screws to avoid damaging particleboard core.

Installation with Legs

For use with IKEA ADILS or similar screw-in legs.

1. Place tabletop upside down on protected surface.
2. Screw each leg into pre-drilled holes by turning clockwise.
3. Ensure legs are fully tightened and perpendicular to tabletop.
4. Turn tabletop over and check stability on floor.
5. Adjust leg levelers (if available) for uneven floors.

Note: Use only legs designed for this tabletop thickness.

Installation with Frame

For use with TORSBY underframe or similar table frames.

1. Assemble frame according to its instructions.
2. Place frame upside down on protected surface.
3. Position tabletop upside down over frame, aligning mounting holes.
4. Insert bolts through frame brackets into tabletop.
5. Tighten bolts securely with provided tool.
6. Carefully flip assembled table upright.

CAUTION! Ensure frame is centered before tightening to prevent imbalance.

Weight Capacity

• Maximum distributed load: 50 kg (evenly distributed).
• Point load: Avoid placing more than 25 kg on a single small area.
• Dynamic load: Not designed for standing, sitting, or climbing.

WARNING! Exceeding weight limits may cause damage or collapse.

Care & Maintenance

Clean with damp cloth and mild detergent; dry immediately.

1. Wipe spills promptly with soft, damp cloth.
2. Use mild soap solution for stubborn stains; avoid abrasive cleaners.
3. Do not use solvents, ammonia, or abrasive pads.
4. Protect from sharp objects and hot items (use coasters or mats).

CAUTION! Melamine surface is resistant to scratches but not cut-proof. Avoid dragging heavy or sharp objects across surface.

Troubleshooting

Note: For missing parts or damage, contact IKEA customer service.

Warranty Information

IKEA limited warranty applies as per local IKEA terms. Warranty covers material and manufacturing defects under normal household use. Proof of purchase required. For support, visit www.ikea.com or contact your local IKEA store.

Copyright: © Inter IKEA Systems B.V. All rights reserved.