IKEA TARVA 103.607.04 5 Drawer Chest instructions manual

The IKEA TARVA 103.607.04 is a 5-drawer chest made from solid pine, featuring a natural wood finish that can be stained, painted, or left untreated. Designed for bedroom storage, it includes five spacious drawers with metal runners for smooth operation, a sturdy frame construction, and an optional wall attachment for safety. Below are key sections for safety, parts list, assembly instructions, care, and warranty information.

Parts & Hardware

All components included in the package. Check against list before assembly.

Safety Instructions

Read all instructions before assembly. Use proper tools and work on a clean, flat surface.

1. Keep small parts away from children during assembly.
2. Assemble on a soft surface to avoid scratching parts.
3. Use two people for lifting and positioning large panels.
4. Always attach chest to wall using provided hardware to prevent tipping.
5. Do not exceed drawer weight capacity (see specifications).

WARNING! Serious or fatal crushing injuries can occur from furniture tipping over. Always secure this chest to the wall.

Assembly Steps

Follow numerical order shown in assembly guide. Estimated time: 60-90 minutes.

1. Lay side panels flat. Insert wooden dowels into pre-drilled holes.
2. Attach bottom panel to side panels using cam locks. Tighten with screwdriver.
3. Attach top panel to side panels using remaining cam locks.
4. Slide back panel into grooves at rear of frame. Secure with provided nails or screws.
5. Ensure all joints are tight and frame is square before proceeding.

Tip: Do not fully tighten cam locks until all parts are aligned.

Drawer Installation

Install drawers after main frame is assembled and upright.

1. Attach metal runners to inside of chest frame using provided screws.
2. Attach corresponding runner parts to drawer sides.
3. Insert drawer into frame, aligning runners. Push gently until fully seated.
4. Test each drawer for smooth opening and closing.
5. Adjust runners if drawer is uneven or sticks.

Note: Drawers are interchangeable but labeled for optimal fit.

Wall Attachment

Prevent tipping by securing chest to wall stud.

1. Locate wall stud using stud finder.
2. Position chest against wall in desired location.
3. Use provided wall strap and screws to attach top rear of chest to wall stud.
4. Tighten securely. Test stability by gently pulling forward on top.

CAUTION! If no stud is available, use appropriate wall anchors rated for the chest's weight.

Care & Maintenance

Solid pine requires proper care to maintain appearance.

• Dust regularly with a soft, dry cloth.
• For stains, use mild soap and damp cloth. Dry immediately.
• Do not use abrasive cleaners or solvents.
• If unfinished, apply wood oil or stain as desired for protection.
• Avoid placing in direct sunlight or high humidity areas.

Tip: Periodically check and tighten hardware to maintain stability.

Specifications

• Dimensions: Height: 39 ¾" (101 cm), Width: 35 ¾" (91 cm), Depth: 18 ½" (47 cm).
• Material: Frame/Drawer Fronts: Solid pine. Back/Drawer Bottoms: Fiberboard.
• Finish: Untreated pine (can be stained, painted, or oiled).
• Drawer Capacity: Max 22 lbs (10 kg) per drawer.
• Weight: 66 lbs (30 kg) assembled.
• Hardware: Included: Cam locks, dowels, screws, wall attachment kit.
• Tools Required: Phillips screwdriver, hammer (for optional back panel nails).

Troubleshooting

Warranty & Support

IKEA limited warranty applies. See warranty card for details.

Support: For missing parts, assembly help, or product questions:

• Visit: www.ikea.com
• Call IKEA customer service: 1-888-888-4532
• Reference product number: 103.607.04

Recycling: Disassemble and recycle materials according to local regulations.