IKEA SVARTNORA 704.594.48 Floor Lamp instructions manual

The IKEA SVARTNORA 704.594.48 is a modern floor lamp designed for ambient lighting. It features a sturdy metal frame, an adjustable shade for directing light, an E26/E27 socket compatible with LED, CFL, or halogen bulbs (max 13W LED/15W CFL/40W halogen), and a foot switch for easy on/off control. Below are key sections for safety, assembly, installation, operation, care, and troubleshooting.

1. Safety Information 2. Package Contents 3. Assembly Instructions 4. Installation & Setup 5. Specifications 6. Operation 7. Care & Maintenance 8. Troubleshooting 9. Warranty & Support

Safety Information

Read all instructions before assembly and use.

Warning	Description
Electrical Safety	Ensure power is off during assembly. Use only with correct voltage (120V).
Bulb Compatibility	Do not exceed maximum wattage (13W LED/15W CFL/40W halogen).
Placement	Place on stable, level surface away from heat sources and water.
Children & Pets	Keep out of reach of young children and pets to prevent tipping.
Cord Management	Do not pinch or damage cord; keep away from walkways.

WARNING! Risk of electric shock or fire if misused. Unplug before cleaning or maintenance.

Package Contents

Inspect all parts before assembly. Contact IKEA if any items are missing.

Base: 1 piece (metal).
Pole Sections: 2 pieces (to be connected).
Lamp Shade: 1 piece (adjustable).
Socket & Cord Set: Pre-assembled with foot switch.
Hardware Bag: Contains screws and Allen key.
Instruction Manual: This document.

Note: Bulb not included.

Assembly Instructions

Estimated assembly time: 15-20 minutes. Tools required: Allen key (provided).

Attach Base: Insert bottom pole section into base; secure with provided screw using Allen key.
Connect Pole: Screw top pole section onto bottom section by hand until tight.
Install Shade: Slide shade over top of pole; align and tighten set screw with Allen key.
Route Cord: Ensure power cord runs neatly along pole into base.
Final Check: Ensure all connections are tight and lamp stands upright without wobbling.

CAUTION! Do not overtighten screws. Assemble on soft surface to avoid scratches.

Installation & Setup

After assembly, install bulb and plug in lamp.

Install Bulb: Ensure lamp is unplugged. Screw compatible bulb (max 13W LED) into socket firmly but do not overtighten.
Adjust Shade: Tilt shade to desired angle for optimal light direction; tighten adjustment knob if loose.
Plug In: Connect power cord to wall outlet.
Test Operation: Press foot switch to turn lamp on/off. Light should respond immediately.

Tip: For best light distribution, position lamp in corner or beside furniture.

Specifications

Model: SVARTNORA 704.594.48
Type: Floor Lamp
Material: Metal frame, fabric/plastic shade
Height: Adjustable approx. 55-60 inches (140-152 cm)
Bulb Socket: E26/E27 standard
Max Wattage: 13W LED / 15W CFL / 40W Halogen
Switch Type: Foot switch (on/off)
Cord Length: 6 ft (1.8 m)
Voltage: 120V AC, 60Hz
Weight: 5.5 lbs (2.5 kg) assembled

Operation

Simple on/off operation via foot switch.

Foot Switch: Press once to turn on; press again to turn off. Ensure foot is placed firmly on switch.

Shade Adjustment: Loosen knob on shade, tilt to desired angle, retighten knob.

Bulb Replacement: Always unplug lamp first. Allow bulb to cool if recently used. Unscrew old bulb, replace with compatible bulb, plug in, and test.

Note: Lamp is designed for indoor use only. Do not use with dimmer switches unless bulb is dimmable.

Care & Maintenance

Unplug lamp before any cleaning.

Exterior: Wipe with dry or slightly damp cloth. Do not use abrasive cleaners.
Shade: Dust with soft brush or vacuum with brush attachment. For fabric shades, spot clean with mild detergent if needed.
Cord: Check periodically for damage. Do not pull cord to unplug.
Storage: Disassemble if storing long-term. Keep in dry place.

CAUTION! Never immerse lamp in water or use liquid cleaners directly on electrical parts.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Lamp does not turn on	No power / faulty bulb	Check outlet; try another device. Replace bulb. Ensure foot switch is fully pressed.
Lamp flickers	Loose bulb / poor connection	Turn off, unplug, tighten bulb. Check bulb type compatibility.
Lamp wobbles	Uneven surface / loose assembly	Place on level floor. Tighten all screws and pole connections.
Shade does not stay adjusted	Loose adjustment knob	Tighten knob on shade. Do not overtighten.
Overheating	Bulb wattage too high	Immediately turn off and unplug. Replace with bulb of correct max wattage.

Reset: Unplug for 1 minute, then plug back in.

Warranty & Support

IKEA limited warranty applies. See IKEA terms or receipt for details.

Support: For missing parts, assembly help, or product questions:

Visit: www.ikea.com
Contact IKEA Customer Service: 1-888-888-4532
Reference Model: SVARTNORA 704.594.48

Recycling: Dispose of packaging and lamp according to local regulations. Recycle electronics appropriately.