The IKEA STÄNKREGN 705.421.60 is a modern ring-shaped LED lamp designed for ambient lighting. It features a minimalist metal ring design, integrated LED light source with adjustable brightness, touch or remote control operation (model dependent), and a versatile mounting system for wall or ceiling installation. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.
Key components: Metal ring frame, Integrated LED module, Mounting bracket, Power adapter/cable, Remote control (if included), Wall anchors and screws.
| Feature | Description |
|---|---|
| Ring Design | Minimalist circular metal frame for modern aesthetics |
| LED Light Source | Energy-efficient, long-life integrated LEDs |
| Brightness Control | Dimmable via touch or remote (models vary) |
| Mounting System | Bracket for secure wall or ceiling mounting |
| Power Input | Low-voltage DC input via power adapter |
| Control Method | Touch sensor on ring or infrared remote |
| Light Color | Warm white (typical, check packaging) |
| IP Rating | Indoor use only (typically IP20) |
Unpack and inspect all parts. Ensure you have the correct tools (screwdriver, drill, level).
WARNING! Ensure the power is OFF during installation. The lamp may be fragile; handle with care to avoid bending the ring.
After installation, power on the lamp and configure basic operation.
CAUTION! Do not mount near heat sources or in damp locations. Use appropriate fixings for your wall type.
Operation via touch sensor on the ring or included remote control.
Touch Control (typical): Single tap: On/Off. Tap and hold: Brightness increase/decrease.
Remote Control (if included): POWER On/Off, Brightness +/-, Mode (if multiple light modes).
No complex menus or settings. The lamp operates with basic dimming functionality. Ensure the remote has line-of-sight to the lamp's sensor (usually on the front or side).
Use only the provided power adapter and cable.
Tip: Do not use a damaged adapter or cable. Keep cables tidy to avoid tripping hazards.
Simple daily use instructions.
WARNING! Do not touch the LEDs directly when on for extended periods as they may become warm. Not for use as a primary task light.
Overheat Protection: Integrated circuit may dim or shut off if overheating is detected. Low Voltage: Operates on safe low-voltage DC from the adapter. Stable Mounting: Bracket designed to securely hold the lamp's weight.
Disconnect from power before cleaning. Use a soft, dry or slightly damp cloth to wipe the metal ring. Do not use abrasive cleaners, solvents, or water sprays.
CAUTION! Never immerse the lamp or adapter in water. Avoid getting moisture into any openings.
This product complies with applicable CE directives and RoHS standards. The LED light source is integrated and not replaceable; the entire product must be replaced at end of life. Dispose of according to local electronic waste regulations. IKEA and STÄNKREGN are trademarks of Inter IKEA Systems B.V. For support, visit www.ikea.com or contact your local IKEA customer service.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Lamp does not turn on | No power | Check if outlet works; ensure adapter is plugged in firmly to both lamp and wall. |
| Light is dim or flickering | Loose connection / adapter issue | Check all cable connections. Try a different outlet. Adapter may be faulty. |
| Touch control not responding | Sensor dirty / lamp overheated | Clean sensor area with dry cloth. Let lamp cool down if it was on for hours. |
| Remote not working | Batteries / obstacles | Replace remote batteries. Ensure you are pointing remote at sensor with no obstructions. |
| Lamp becomes warm | Normal operation | LEDs generate some heat. Ensure there is at least 10cm clearance around lamp for ventilation. |
Reset: Disconnect power for 30 seconds, then reconnect.
Service: For non-working parts within warranty, contact IKEA customer service. Do not attempt to open or repair the lamp yourself.