The IKEA STYRBAR 504.636.15 is a wireless remote control designed to operate compatible IKEA smart lighting products. It features a minimalist design, battery-powered operation (CR2032), and supports basic functions like turning lights on/off, adjusting brightness, and controlling color temperature for compatible white spectrum bulbs. Below are key sections for safety, features, installation, setup, operation, pairing, and troubleshooting.
Key components: Compact remote control unit, battery compartment, function buttons, pairing button, and LED indicator.
| Feature | Description |
|---|---|
| Power Button | Turns paired lights on or off |
| Brightness Controls | + and - buttons to increase or decrease light intensity |
| White Spectrum Control | Cycles through warm white to cool white temperatures (on compatible bulbs) |
| Pairing Button | Used to connect the remote to new lights |
| LED Indicator | Flashes to confirm pairing or low battery |
| Battery Compartment | Holds one CR2032 coin cell battery |
| Mounting Options | Can be placed on a table or mounted on a wall with included adhesive pad |
| Wireless Range | Up to 10 meters indoors (may vary) |
| Compatibility | Works with IKEA TRÅDFRI and other compatible smart lights (Zigbee based) |
Unpack and verify all items are present.
WARNING! Keep battery away from children. If swallowed, seek medical help immediately.
Insert battery before first use.
CAUTION! Use only CR2032 battery type. Do not mix old and new batteries.
Front face features four main buttons and a central pairing button.
Top Button (I/O): Power On/Off for all paired lights.
Right Button (+): Increases brightness.
Left Button (-): Decreases brightness.
Bottom Button (Sun/Moon Icon): Cycles white light color temperature (warm to cool).
Center Button (Pairing): Small recessed button, used for pairing/reset (press with a paperclip).
LED Indicator: Located near the pairing button. Flashes green briefly on successful button press. Flashes red when battery is low.
The remote must be paired with your light(s) to control them.
Tip: One remote can control multiple lights paired to it simultaneously.
Once paired, use the remote to control your lights.
Note: For color bulbs, this remote only controls on/off and brightness unless paired via a gateway for advanced features.
Reset to clear all paired lights and restore factory settings.
WARNING! Resetting will un-pair the remote from all previously connected lights.
Clean with a soft, dry cloth. Do not use liquids or abrasive cleaners.
CAUTION! Do not expose to extreme temperatures, moisture, or direct sunlight for prolonged periods. Dispose of battery according to local regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Contains FCC ID: [To be filled by manufacturer]. This product may be subject to radio frequency regulations in your country. For EU: CE marking indicates conformity with relevant EU directives. Disposal: Do not dispose of with household waste. Recycle according to local electronic/battery recycling rules. IKEA and STYRBAR are trademarks of Inter IKEA Systems B.V.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Remote does not work | Dead battery, out of range, not paired | Replace battery; move closer to light; re-pair the remote. |
| Light does not respond | Light not in pairing mode, power issue | Ensure light is powered; reset light and re-pair with remote. |
| LED flashes red | Low battery | Replace the CR2032 battery immediately. |
| Cannot pair remote | Timing incorrect, interference | Follow pairing steps precisely within 10-second window; reduce wireless interference. |
| Controls wrong light | Multiple remotes in area, accidental pairing | Reset the remote and the light, then re-pair them exclusively. |
Reset All: Reset both remote and light, then attempt pairing again.
Support: Visit IKEA website or contact your local IKEA store for assistance.