IKEA STRÅLA 705.629.64 Table Lamp instructions manual

The IKEA STRÅLA 705.629.64 is a modern table lamp featuring a sleek metal base and a fabric shade, designed to provide ambient lighting. It includes an integrated LED light source with a long lifespan, an on/off switch on the cord, and requires assembly. Below are key sections for safety, features, assembly, operation, care, and troubleshooting.

Features at a Glance

Key components: Metal base, Fabric shade, Integrated LED module, Power cord with on/off switch.

Assembly Instructions

Unpack all parts and check contents. Ensure you have a clean, flat surface.

1. Attach the base: If separate, screw the base plate to the lamp stem using provided hardware.
2. Attach the shade: Place the fabric shade over the top of the lamp frame. Ensure it sits evenly and securely.
3. Secure the shade: Some models may have a finial or clip; tighten gently to hold shade in place.
4. Route the cord: Arrange the power cord neatly from the base to your outlet.

WARNING! Do not plug in the lamp during assembly. Ensure all parts are firmly connected to prevent instability.

First-Time Setup

After assembly, place the lamp on a stable, level surface.

1. Positioning: Choose a location away from edges, heat sources, and moisture.
2. Plug in: Connect the power cord to a standard 120V wall outlet.
3. Power on: Use the switch on the cord to turn the lamp on. The LED should illuminate immediately.
4. Adjust placement: For optimal lighting, position the lamp where light is needed without glare.

CAUTION! Ensure the lamp is not covered by any material (e.g., fabric) which could cause overheating.

Specifications

• Product Name: STRÅLA Table Lamp.
• Article Number: 705.629.64.
• Dimensions: Height: 15.75" (40 cm), Shade Diameter: 9.8" (25 cm).
• Weight: Approx. 2.2 lbs (1 kg).
• Material: Base: Steel, powder-coated. Shade: 100% polyester.
• Light Source: Integrated LED, non-replaceable by user.
• Light Color: Warm white (2700K).
• Luminous Flux: 400 lumens.
• Input Power: 6 W.
• Voltage: 120V AC, 60Hz.
• Estimated Lifespan: 25,000 hours.

Controls and Operation

The lamp is operated solely by the on/off switch on the power cord. There are no dimmers or adjustable settings.

Operation: Press the switch to turn the lamp ON. Press again to turn OFF. The LED provides instant light with no warm-up time.

Note: This lamp does not support dimming via external dimmer switches. Using a dimmer may damage the LED driver or cause flickering.

Lamp Placement

For safety and optimal performance, follow these placement guidelines.

1. Use on a stable, horizontal surface such as a bedside table, desk, or shelf.
2. Keep at least 3 inches away from walls or other objects for proper ventilation.
3. Avoid placement in areas with high humidity (e.g., bathrooms) unless specified.
4. Keep out of reach of young children to prevent tipping or cord entanglement.

Tip: Use the lamp for ambient lighting, reading, or as an accent light in living spaces.

Replacing the Light Source

IMPORTANT: The LED light source is integrated and is not designed to be replaced by the user. If the light fails, the entire lamp unit must be replaced.

1. Do not attempt to open the lamp housing to access the LED.
2. If the lamp stops working while under warranty, contact IKEA customer service.
3. For end-of-life disposal, follow local regulations for electronic waste.

WARNING! Attempting to replace the integrated LED voids the warranty and may result in electric shock or damage.

Safety Information

Read all instructions before use. Keep for future reference.

• This lamp is for indoor use only.
• Do not use outdoors or in wet locations.
• Do not place near open flames, hot surfaces, or in direct sunlight.
• Unplug before cleaning or moving the lamp.
• Do not use if the cord or plug is damaged.
• Use only with the provided power supply specifications.
• Not intended for use with light dimmers or timers unless compatible.

CAUTION: Risk of electric shock. The integrated LED contains no user-serviceable parts.

Care & Cleaning

Unplug the lamp and allow it to cool completely before cleaning.

1. Base: Wipe with a soft, dry cloth. For stubborn marks, use a slightly damp cloth. Do not use abrasive cleaners.
2. Shade: Dust gently with a soft brush or use the low suction setting of a vacuum cleaner with a soft brush attachment. Do not wash or immerse the shade in water.
3. Cord: Wipe with a dry cloth. Ensure the cord is not pinched or damaged.

CAUTION! Never use harsh chemicals, solvents, or abrasive materials. Do not spray liquids directly onto the lamp.

Warranty & Support

IKEA products are covered by a limited warranty. Refer to the IKEA warranty document included with your purchase or available at IKEA stores for specific terms and duration.

Support: For assembly help, spare parts, or product questions, visit www.ikea.com or contact your local IKEA store.

Recycling: At end of life, do not dispose of with household waste. Take to a designated electronic waste recycling point.

Troubleshooting

No User-Serviceable Parts: Do not disassemble the lamp. For persistent issues, contact IKEA support.

IKEA Customer Service: Visit www.ikea.com or call 1-800-434-4532 (US).