IKEA SNÖBYAR 204.598.46 Table Lamp instructions manual

The IKEA SNÖBYAR 204.598.46 is a modern table lamp designed for ambient lighting. It features a durable construction with a fabric shade, an integrated on/off switch on the cord, and uses a standard E26/E27 bulb (max 7W LED or 40W incandescent). Below are key sections for safety, assembly, operation, care, and troubleshooting.

1. Safety Information 2. Package Contents 3. Assembly Instructions 4. Specifications 5. Operation & Controls 6. Bulb Replacement 7. Care & Maintenance 8. Troubleshooting 9. Warranty & Support

Safety Information

Read all instructions before assembly and use.

Warning	Description
Electrical Safety	Use only with correct voltage (120V). Do not immerse in water.
Bulb Wattage	Do not exceed maximum wattage (7W LED or 40W incandescent).
Heat	Lamp may become hot during use. Keep away from flammable materials.
Cord Safety	Do not run cord under carpets or furniture. Avoid pinching.
Children	Keep out of reach of young children. Not a toy.

Package Contents

Unpack and verify all parts are present.

Lamp base (1 piece)
Fabric shade (1 piece)
Socket with cord and integrated switch (pre-assembled)
Instruction manual (this document)

NOTE: Bulb not included. Contact IKEA if any parts are missing.

Assembly Instructions

Assembly requires no tools. Follow steps in order.

Place the lamp base on a stable, flat surface.
Gently slide the fabric shade over the socket assembly until it rests securely on the base.
Ensure the shade is straight and not tilted.
Screw in a compatible bulb (E26/E27 base, max 7W LED or 40W incandescent).
Plug the cord into a standard wall outlet.

CAUTION! Do not force parts. Ensure lamp is unplugged during assembly.

Specifications

Model: SNÖBYAR 204.598.46
Type: Table Lamp
Material: Steel base, Polyester fabric shade
Bulb Socket: E26/E27 (standard)
Max Wattage: 7W LED or 40W incandescent
Cord Length: 6 feet (1.8 meters)
Switch: Integrated on/off switch on cord
Voltage: 120V AC, 60Hz
Dimensions: Height: 12 inches (30 cm), Base diameter: 5 inches (13 cm)

Operation & Controls

The lamp is operated via the integrated switch on the power cord.

To Turn On: Press the switch to the "I" position.

To Turn Off: Press the switch to the "O" position.

Positioning: Place on a stable, level surface. Adjust shade angle if needed by gently tilting (do not force).

Bulb Replacement

Always unplug lamp before replacing bulb.

Allow bulb to cool completely if recently used.
Unplug lamp from outlet.
Unscrew old bulb counterclockwise.
Screw in new compatible bulb (E26/E27, max 7W LED or 40W incandescent) clockwise until snug.
Plug lamp back in and test with switch.

WARNING! Do not touch bulb with wet hands. Do not exceed max wattage.

Care & Maintenance

Unplug before cleaning.

Fabric Shade: Use a soft, dry cloth or a vacuum with a brush attachment. Do not wash.

Base: Wipe with a dry or slightly damp cloth. Do not use abrasive cleaners.

Cord: Wipe with dry cloth. Check regularly for damage.

CAUTION! Never immerse lamp in water or use liquid cleaners.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Lamp does not turn on	Bulb burnt out; not plugged in; switch off	Replace bulb; ensure plug is secure; flip switch to "I".
Lamp flickers	Loose bulb; faulty bulb	Turn off, unplug, and tighten bulb. Try a new bulb.
Shade is loose	Not fully seated on base	Unplug, gently press shade down until secure.
Lamp gets very hot	Bulb wattage too high	Use a lower wattage bulb (max 7W LED or 40W incandescent).
Switch feels stuck	Debris in switch	Unplug, clean switch area with dry cloth. Do not force.

Warranty & Support

This IKEA product is covered by a limited warranty. Refer to the IKEA warranty document included with your purchase or visit www.ikea.com.

For Support: Visit www.ikea.com or contact your local IKEA store.

Recycling: Dispose of according to local regulations for electronic waste.