IKEA SMÅGÖRA 904.608.94 Wardrobe instructions manual

The IKEA SMÅGÖRA 904.608.94 is a freestanding wardrobe designed for bedroom storage, featuring a modern design with sliding doors, adjustable shelves, and a hanging rail. It requires assembly and comes with all necessary hardware. Below are key sections for safety, parts list, assembly instructions, installation, care, and warranty information.

Parts & Hardware Included

Before assembly, verify all parts are present. Key components: Wardrobe frame panels, sliding doors, back panel, shelves, hanging rail, cam locks, screws, dowels, and wall attachment device.

Safety Information

Read all instructions before assembly. Ensure a clean, spacious area.

1. Tip-over prevention: This wardrobe must be securely attached to the wall using the provided wall attachment device to prevent tipping, especially in households with children.
2. Lifting safety: The panels are heavy; use two people for lifting and assembly to avoid injury.
3. Tool safety: Use the included Allen key carefully; keep tools away from children.
4. Stable surface: Assemble on a soft, flat surface (e.g., carpet) to avoid scratching panels.

WARNING! Serious or fatal crushing injuries can occur from furniture tip-over. Always secure this wardrobe to the wall.

Assembly Instructions

Follow steps in order. Estimated assembly time: 60-90 minutes.

1. Prepare: Unpack all parts, lay them flat. Identify all hardware using the parts list.
2. Assemble frame: Connect side panels to top and bottom panels using dowels and cam locks. Tighten cam locks clockwise with the Allen key until firm.
3. Attach back panel: Place the assembled frame face down on a soft surface. Align the back panel and secure it with the provided screws using a screwdriver.
4. Install hanging rail: Insert the hanging rail into the pre-drilled holes on the side panels and secure with screws.
5. Install shelves: Place adjustable shelves on the shelf support pins at desired heights.
6. Mount doors: Attach the sliding door hardware to the top and bottom of the frame. Hang the doors by aligning the wheels with the tracks. Adjust door alignment as needed.
7. Final check: Ensure all cam locks are tight, doors slide smoothly, and the wardrobe is square.

Tip: Do not overtighten cam locks; this may strip the particleboard.

Installation & Placement

Choose a suitable location before moving the assembled wardrobe.

1. Location: Place on a firm, level floor. Ensure there is enough space for doors to slide open fully.
2. Wall attachment: Locate a solid wall stud. Use the provided wall attachment bracket and screws to secure the top rear of the wardrobe to the wall. This is mandatory.
3. Leveling: Check that the wardrobe is level using a spirit level. Adjust by placing shims under the base if necessary.
4. Clearance: Maintain at least 2 inches (5 cm) clearance from heaters, radiators, or other heat sources.

CAUTION! Never place the wardrobe near open flames or high humidity areas like bathrooms.

Adjusting Shelves & Doors

The wardrobe allows customization of interior space.

Shelves: Remove shelf, reposition the metal shelf support pins in the pre-drilled holes on the side panels, and place the shelf back. Ensure it is level and secure.

Sliding Doors: - Vertical adjustment: Use an Allen key to turn the adjustment screws at the bottom of each door to raise or lower it. - Horizontal alignment: Adjust the top guide by loosening the screw, moving the door left/right, and retightening. - Closing gap: If doors do not close flush, adjust the rear stoppers on the top track.

Note: Make small adjustments and test the door slide after each turn.

Care & Maintenance

Proper care extends the life of your wardrobe.

• Cleaning: Wipe exterior and interior with a soft, damp cloth. Use mild soap if needed. Dry immediately. Do not use abrasive cleaners, scouring pads, or solvents.
• Door tracks: Keep the top and bottom door tracks clean and free of debris. Vacuum dust periodically.
• Hardware check: Periodically check and tighten cam locks and screws, especially after moving the wardrobe.
• Weight limit: Do not exceed 55 lbs (25 kg) per shelf. The hanging rail is rated for 66 lbs (30 kg) of distributed weight.

WARNING! Never climb on or hang from the shelves or doors.

Specifications

• Model: SMÅGÖRA
• Article Number: 904.608.94
• Dimensions (W x H x D): 47 1/4" x 74 3/4" x 19 5/8" (120 cm x 190 cm x 50 cm)
• Weight: 88 lbs (40 kg)
• Material: Particleboard, Fiberboard, ABS plastic, Steel
• Finish: White, Ash veneer
• Door Type: Sliding doors
• Interior: 2 adjustable shelves, 1 fixed hanging rail
• Max Load (Shelf): 55 lbs (25 kg)
• Max Load (Rail): 66 lbs (30 kg)

Troubleshooting

Reset: If major issues occur, disassemble and reassemble from step 1, following instructions precisely.

Warranty & Support

This IKEA product is covered by a limited warranty. Refer to the IKEA warranty leaflet included in the packaging for full terms and conditions.

• Warranty Period: Varies by region; typically 1-10 years for different components (e.g., 10 years for frame).
• Support: For missing parts, assembly help, or warranty claims:
  Visit: www.ikea.com
  Contact your local IKEA store.
  Phone (US): 1-888-888-4532
• Recycling: At end of life, disassemble and recycle materials according to local regulations. Many IKEA stores offer take-back programs.

Disclaimer: IKEA reserves the right to make changes to product specifications. Always refer to the article number (904.608.94) when seeking support.