IKEA SKRUVBY 105.427.47 TV Stand instructions manual

The IKEA SKRUVBY 105.427.47 is a modern TV stand designed for stability and cable management. It features a clean design, integrated cable routing channels, adjustable shelf heights, and sturdy construction. Below are key sections for safety, parts list, assembly instructions, use, care, and warranty information.

Parts & Hardware

All components included in the package.

Safety Instructions

Read all instructions before assembly. Ensure a safe workspace.

1. Work Area: Assemble on a soft, clean surface to avoid scratches.
2. Lifting: TV stand is heavy; use two people for lifting and moving.
3. Tools: Use only the provided Allen key. Do not overtighten screws.
4. Stability: Attach to wall using the provided anti-tip device if included, especially in households with children.
5. Weight Distribution: Do not exceed maximum load limits.

WARNING! Failure to follow safety instructions may result in injury or damage to the product.

Assembly Steps

Follow the numbered steps in the included pictorial guide.

1. Step 1: Identify all parts using the parts list.
2. Step 2: Connect Side Panels to Bottom Panel using wooden dowels and cam locks.
3. Step 3: Attach the Back Panel to the frame using provided screws.
4. Step 4: Install the adjustable shelf onto the support pins at desired height.
5. Step 5: Attach the Top Panel to the frame using cam locks.
6. Step 6: Screw in the four adjustable feet to the bottom of the side panels.
7. Step 7: Place the unit in its desired location and use a level to adjust feet for stability.
8. Step 8: Secure the unit to the wall using the anti-tip bracket (if included).

Tip: Do not fully tighten cam locks until all parts are aligned.

Specifications

• Model: SKRUVBY 105.427.47
• Color: Black-Brown
• Dimensions (W x H x D): 120cm x 40cm x 40cm (47.2" x 15.7" x 15.7")
• Material: Particleboard, Fiberboard, ABS plastic, Steel
• Top Panel Max Load: 50 kg (110 lbs)
• Shelf Max Load: 15 kg (33 lbs) per shelf
• Adjustable Shelf Heights: 3 positions
• Weight of Product: 25 kg (55 lbs)
• Cable Management: Integrated rear channels and holes
• Warranty: See limited warranty terms.

Adjustments & Features

After assembly, you can customize your TV stand.

Adjustable Shelf: Lift shelf up and out to reposition on different support pins inside the cabinet.

Leveling Feet: Turn feet clockwise to raise that corner, counter-clockwise to lower it. Use a spirit level on the top surface.

Wall Attachment: Use the provided bracket and screws to secure the top rear of the stand to a wall stud.

Door/ Drawer Installation (if applicable): Follow separate leaflet for hinge or slide mounting.

Cable Management

Designed to hide and organize cables for a clean look.

1. Route power strips and excess cable through the large opening in the back panel.
2. Use the plastic cable clips (if included) to bundle cables along the designated channels inside the back panel.
3. For devices on the shelf, feed cables through the smaller holes in the shelf or back panel.
4. Ensure cables are not pinched when moving the shelf or during assembly.

Tip: Label cables during setup for easier identification later.

Weight Limits & Placement

To ensure longevity and safety, adhere to these guidelines.

• Place the stand on a flat, level, and solid floor.
• Do not place near direct heat sources (radiators, heaters) or in areas of high humidity.
• Distribute weight evenly. Place heaviest items (e.g., center channel speaker) in the center of the shelf/top.
• Maximum Load Top: 50 kg. Maximum Load per Shelf: 15 kg.
• Ensure the TV's base does not overhang the edges of the top panel.

CAUTION! Exceeding weight limits can cause structural failure.

Care & Maintenance

Proper care will keep your TV stand looking new.

Cleaning: Wipe with a soft, slightly damp cloth. Wipe dry immediately. Use a mild detergent if needed.

Avoid: Abrasive cleaners, scouring pads, solvents (e.g., acetone), and excessive water.

Protection: Use coasters under drinks and mats under hot items to prevent damage to the surface.

Tightening: Check and tighten cam locks and screws every 6-12 months as wood may settle.

CAUTION! Never drag the stand across the floor. Lift it to move.

Warranty Information

IKEA of Sweden AB provides a limited warranty. This warranty is valid only for the original purchaser from an authorized IKEA retailer.

Coverage: Covers material and manufacturing defects for the period defined by local IKEA policies (typically 1-10 years depending on product range).

Not Covered: Damage from incorrect assembly, improper use, neglect, accidents, modification, or exposure to extreme environmental conditions. Normal wear and tear is not considered a defect.

Claim Process: Keep your original receipt. For service, contact your local IKEA store or visit www.IKEA.com.

Troubleshooting

Missing Parts? Contact IKEA customer service with your product number (105.427.47) for spare parts.

Support: Visit www.IKEA.com or your local IKEA store.