IKEA SEKTION 894.054.60 Cabinet Frame instructions manual

The IKEA SEKTION 894.054.60 is a versatile cabinet frame designed for kitchen and storage solutions, featuring a white finish, adjustable legs, and compatibility with various SEKTION doors and drawers. It is constructed from particleboard, fiberboard, and ABS plastic, and requires assembly. Below are key sections for safety, parts list, assembly instructions, installation, adjustment, care, and troubleshooting.

Parts & Hardware Included

Before assembly, verify all parts are present. Key components: Cabinet frame panels, adjustable legs, cam locks, screws, dowels, and mounting brackets.

Safety Information

Read all instructions before assembly. Ensure a safe working environment.

1. Work Area: Assemble on a clean, flat, protected surface to avoid scratches.
2. Lifting: Cabinet is heavy; use two people to lift and position.
3. Tools: Use recommended tools (Phillips screwdriver, hammer). Keep away from children.
4. Mounting: Secure cabinet to wall to prevent tipping, especially if children are present.
5. Electrical: Keep away from water and electrical sources during assembly.

WARNING! Failure to secure cabinet to wall can result in serious injury or death from tipping.

Assembly Instructions

Follow steps in order. Do not fully tighten screws until all parts are aligned.

1. Prepare Panels: Lay all panels flat with finished sides facing up.
2. Insert Dowels: Gently tap dowels into pre-drilled holes on side panels.
3. Connect Side Panels: Attach side panels to bottom panel using cam locks. Turn locks clockwise to tighten.
4. Attach Top Panel: Connect top panel to side panels using remaining cam locks.
5. Install Back Panel: Slide back panel into grooves at rear. Secure with provided screws if necessary.
6. Attach Adjustable Legs: Screw legs into bottom panel at each corner. Do not fully extend yet.
7. Final Check: Ensure all cam locks are fully tightened and panels are square.

Tip: Use a soft mallet to gently tap panels together if needed. Do not force.

Installation & Mounting

For safety and stability, secure cabinet to wall.

1. Position Cabinet: Move assembled frame to desired location.
2. Level Cabinet: Adjust legs to level the cabinet. Use a spirit level.
3. Locate Wall Studs: Use a stud finder to locate solid wood studs in wall.
4. Attach Brackets: Secure mounting brackets to cabinet back panel at top.
5. Secure to Wall: Align brackets with wall studs and fasten with appropriate screws (not included for wall).
6. Final Level Check: Re-check level after mounting and adjust legs if necessary.

CAUTION! Use screws suitable for your wall type (drywall, plaster, stud). Cabinet must be anchored to structural support.

Adjusting Cabinet Frame

Fine-tune for perfect alignment and door operation.

• Height Adjustment: Turn legs clockwise to raise, counter-clockwise to lower.
• Door Alignment (if pre-attached): Adjust hinges by turning screws on hinge arm (in/out, up/down).
• Panel Squareness: If frame is racked, loosen cam locks slightly, square the frame, and re-tighten.

Note: Adjust doors only after frame is level and securely mounted.

Attaching Doors & Drawers

This frame is compatible with SEKTION door/drawer fronts. Hardware sold separately.

1. Install Hinges: Attach hinges to door according to hinge instructions.
2. Mount Doors: Hook hinges onto mounting plates installed inside cabinet frame. Adjust for gap and alignment.
3. Install Drawer Runners: Attach runners to cabinet sides according to runner instructions.
4. Attach Drawer Fronts: Connect drawer front to drawer box and adjust alignment.

Tip: Leave a small gap (2-3mm) between doors for smooth operation.

Specifications

• Article Number: 894.054.60
• Color: White
• Material: Particleboard, Fiberboard, ABS Plastic
• Dimensions (HxWxD): 30" x 15" x 15" (Approximate. Confirm on product packaging)
• Adjustable Leg Height: Up to 1.5"
• Max Load Weight: Refer to IKEA product page for specific weight limits.
• Compatibility: SEKTION kitchen system doors, drawers, and interior organizers.

Care & Maintenance

Clean with a damp, soft cloth. Wipe dry immediately.

• Daily Cleaning: Use water and a mild detergent. Avoid abrasive cleaners.
• Stain Removal: For stubborn stains, use a mild soap solution. Test on hidden area first.
• Avoid: Do not use solvents, abrasive pads, or ammonia-based cleaners.
• Hardware: Periodically check and tighten screws and hinges.

WARNING! Excess moisture can cause particleboard to swell. Never soak or steam clean.

Warranty Information

IKEA limited warranty applies. Refer to the IKEA warranty document included with purchase or available at IKEA stores and www.IKEA.com.

Coverage: Warranty covers material and manufacturing defects under normal household use for the specified period.

Support: For warranty claims or spare parts, contact IKEA Customer Service or visit your local IKEA store with your receipt and article number (894.054.60).

Troubleshooting

Replacement Parts: Visit IKEA.com or an IKEA store for spare parts (e.g., cam locks, dowels, legs).

Customer Service: 1-888-888-4532 (IKEA US) | www.IKEA-usa.com