IKEA SEKTION 002.655.09 Cabinet Frame instructions manual

The IKEA SEKTION 002.655.09 is a versatile cabinet frame designed for kitchen and storage solutions, part of the SEKTION modular system. It features a white finish, adjustable legs, and is compatible with a wide range of doors, drawers, and interior organizers. Below are key sections for safety, parts list, assembly instructions, installation, adjustment, and care.

Parts and Hardware Included

Before assembly, verify all parts are present. Key components: Cabinet frame panels, adjustable legs, cam locks, screws, dowels, and mounting brackets.

Tools Required

Gather these tools before starting assembly.

• Phillips screwdriver or cordless drill with Phillips bit
• Hammer (for tapping dowels)
• Level
• Tape measure
• Pencil
• Safety glasses (recommended)

Safety Instructions

WARNING! To prevent injury and damage, follow these safety guidelines.

1. Work Area: Assemble on a clean, flat, protected surface to avoid scratching.
2. Lifting: Cabinet is heavy; use two people for lifting and positioning.
3. Secure Mounting: Always secure cabinet to wall using provided brackets to prevent tipping.
4. Tool Safety: Wear safety glasses when using hammer or drill.
5. Children: Keep children and pets away from assembly area.

CAUTION! Do not exceed maximum load capacity. Ensure wall can support cabinet weight.

Assembly Step-by-Step

Follow steps in order. Do not fully tighten screws until all parts are aligned.

1. Attach legs: Screw four adjustable legs into pre-drilled holes on bottom panel.
2. Insert dowels: Tap dowels into pre-drilled holes on side panels using hammer.
3. Connect side and top/bottom panels: Align dowels with holes, join panels, and secure with cam locks (turn clockwise to lock).
4. Install back panel: Slide back panel into grooves on side and top/bottom panels. Secure with provided screws.
5. Attach mounting brackets: Screw brackets to top inside rear of cabinet as indicated.
6. Final check: Ensure all joints are tight and cabinet is square. Attach cover caps to leg screws.

Tip: Lay cabinet on its back during assembly for easier access.

Mounting and Installation

Proper wall mounting is critical for safety.

1. Locate studs: Use stud finder to locate wall studs. Mark positions with pencil.
2. Position cabinet: With help, lift cabinet into desired position. Use level to ensure it is perfectly horizontal.
3. Adjust legs: Turn legs to level cabinet and achieve correct height.
4. Secure to wall: Drill screws through mounting brackets into wall studs. Ensure screws are tight.
5. Final level check: Re-check level after securing.

WARNING! If mounting into drywall without studs, use appropriate wall anchors rated for cabinet weight.

Adjusting Doors and Drawers

For compatible SEKTION doors and drawers.

• Door alignment: Adjust hinges by turning screws on hinge arm (in/out, up/down).
• Drawer slides: Adjust drawer height via screws on side-mounted runners.
• Soft-close: If equipped, ensure mechanism is engaged; adjust tension if necessary.

Note: Refer to specific door/drawer instruction manual for detailed adjustment.

Weight Limits and Specifications

• Model: SEKTION 002.655.09
• Color/Finish: White
• Dimensions (HxWxD): 30" x 15" x 24" (without legs/adjustments)
• Material: Particleboard, foil
• Max Load Capacity: 55 lbs (25 kg) distributed evenly on bottom shelf.
• Adjustable Leg Height Range: 4" to 6"
• Compatibility: All SEKTION system doors, drawers, and interiors.

Care and Maintenance

To maintain appearance and function.

1. Cleaning: Wipe with damp cloth and mild detergent. Dry immediately.
2. Avoid: Abrasive cleaners, scouring pads, excessive water, and harsh chemicals.
3. Inspection: Periodically check tightness of screws, brackets, and leg adjustments.

CAUTION! Do not use steam cleaners. Avoid direct heat sources.

Troubleshooting

Warranty and Support

IKEA limited warranty applies. For missing parts or assembly support:

• IKEA Customer Support: 1-888-888-4532
• Online: Visit www.IKEA-usa.com for assembly videos and guides.
• In-Store: Bring this manual and receipt to your local IKEA for assistance.

Note: Warranty does not cover damage from improper assembly, modification, or misuse.