IKEA RUNSKÄR 194.146.89 Faucet instructions manual

The IKEA RUNSKÄR 194.146.89 is a single-lever kitchen faucet designed for easy installation and reliable operation. It features a pull-out spray head with multiple spray patterns, ceramic disc cartridge for smooth control and drip-free performance, durable chrome finish, and flexible supply lines. Below are key sections for safety, features, installation, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Connecting Water Supply 7. Spray Head Functions 8. Maintenance & Cleaning 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Single-lever handle, pull-out spray head with hose, ceramic disc cartridge, aerator, flexible hot/cold supply lines, mounting hardware.

Feature	Description
Single-lever handle	Controls both water temperature and flow rate
Pull-out spray head	Extends for flexible use; includes spray pattern selector
Ceramic disc cartridge	Ensures smooth operation and prevents leaks
Aerator	Mixes air with water for efficient flow
Flexible supply lines	Pre-connected 16" lines for hot and cold water
Mounting hardware	Includes mounting nut, washer, and deck plate
Spray patterns	Stream and spray modes for different tasks
Hose length	Approximately 59 inches (150 cm)
Finish	Chrome-plated brass for durability
Max water pressure	145 psi (10 bar)

Installation

Unpack and inspect all parts. Ensure work area is clean and dry.

Prepare sink: Remove old faucet if present; clean sink surface.
Mount faucet: Insert faucet through sink hole; secure from below with mounting nut.
Connect supply lines: Attach hot (red) and cold (blue) lines to corresponding water valves.
Connect spray hose: Attach hose to faucet body and secure connection.
Check for leaks: Turn on water supply slowly; inspect all connections.

WARNING! Shut off water supply before installation. Use two wrenches to avoid damaging connections. Do not overtighten.

First-Time Setup

After installation, perform initial setup for optimal operation.

Flush system: Run hot and cold water for 2-3 minutes to clear debris.
Check spray head: Extend hose fully; test both spray patterns.
Adjust handle tension: If needed, use included hex key to tighten handle screw.
Test temperature control: Move handle left for hot, right for cold, center to off.

CAUTION! Ensure water supply valves are fully open after installation. Test for leaks before regular use.

Specifications

Model: RUNSKÄR 194.146.89
Type: Single-lever kitchen faucet with pull-out spray
Finish: Chrome
Material: Brass with chrome plating
Cartridge: Ceramic disc
Hose Length: 59 inches (150 cm)
Supply Lines: 16" flexible connectors included
Max Water Pressure: 145 psi (10 bar)
Min Water Pressure: 14.5 psi (1 bar)
Flow Rate: 1.8 GPM (6.8 L/min) at 60 psi
Warranty: Limited 5-year warranty

Controls and Operation

Handle controls: Lift to turn on water; push down to turn off. Move left for hotter water, right for colder.

Spray Head: Pull to extend; press button on spray head to switch between stream and spray patterns. Release to retract (auto-retract feature).

Aerator: Located at tip of spout; can be removed for cleaning.

Handle Adjustment: If handle becomes loose, tighten set screw with included hex key.

Connecting Water Supply

Standard 1/2" water supply connections. Includes flexible lines with 3/8" compression fittings.

Shut off hot and cold water valves under sink.
Connect red line to hot water valve, blue line to cold water valve.
Hand-tighten connections, then use wrench for additional 1/4 turn.
Turn water valves on slowly; check for leaks at connections.

Tip: Use thread seal tape on connections if needed. Do not cross-thread connections.

Spray Head Functions

Two spray patterns: Stream for filling containers, Spray for rinsing.

Extend hose: Pull spray head from faucet; hose extends automatically.
Select pattern: Press button on spray head to toggle between patterns.
Retract hose: Release spray head; it retracts automatically into place.
Hose lock: Some models include hose lock to keep spray head extended.

WARNING! Do not pull hose at sharp angles. Avoid kinking hose. Do not let spray head hang freely when extended.

Maintenance & Cleaning

Regular cleaning maintains appearance and function.

Clean surface: Use soft cloth with mild soap and water; dry immediately.
Clean aerator: Unscrew aerator periodically; rinse to remove debris.
Clean spray head: Remove mineral deposits with vinegar solution if needed.
Check connections: Periodically inspect for leaks.

CAUTION! Do not use abrasive cleaners, steel wool, or harsh chemicals. Do not use on chrome finish.

Regulatory Information

Complies with ASME A112.18.1/CSA B125.1 plumbing standards. Meets low-lead requirements (lead content < 0.25%). Certified to NSF/ANSI 61 for drinking water system components. For support, visit www.ikea.com or contact IKEA customer service at 1-888-888-4532.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Low water pressure	Clogged aerator	Remove and clean aerator; soak in vinegar if mineral deposits present.
Spray head not retracting	Kinked hose or weight issue	Straighten hose; ensure weight is properly positioned under sink.
Leaking from handle	Worn cartridge	Replace ceramic disc cartridge (part included with faucet).
Water temperature inconsistent	Supply line connections reversed	Check hot/cold connections; red to hot, blue to cold.
Spray pattern not changing	Debris in spray head	Clean spray head; remove and rinse under running water.
Handle loose	Set screw needs tightening	Tighten set screw with included hex key.

Note: For persistent issues, contact IKEA customer service. Do not attempt repairs beyond basic maintenance if unsure.

Service: 1-888-888-4532; www.ikea.com