IKEA REGISSÖR 403.420.73 Cabinet instructions manual

The IKEA REGISSÖR 403.420.73 is a wall-mounted cabinet designed for storage in living rooms, bedrooms, or hallways. It features a clean, modern design with adjustable shelves, concealed mounting hardware, and a sturdy construction. Below are key sections for safety, assembly, installation, use, care, and troubleshooting.

Product Overview

Key components: Cabinet frame, door, adjustable shelves, mounting brackets, hardware pack.

Safety Information

Read all instructions before assembly and installation.

1. Use two people for assembly and mounting to prevent injury.
2. Ensure wall is suitable for mounting (solid wall or studs).
3. Do not exceed maximum weight capacity.
4. Keep small hardware away from children.

WARNING! Cabinet must be securely mounted to wall to prevent tipping. Never allow children to climb on or hang from cabinet.

Included Parts

Check all parts before starting assembly.

1. Cabinet back panel (1)
2. Side panels (2)
3. Top panel (1)
4. Bottom panel (1)
5. Door (1) with hinges pre-attached
6. Adjustable shelves (2)
7. Mounting brackets (2)
8. Hardware pack: Cam locks, screws, wall plugs, shelf pins
9. Assembly instructions (this manual)

CAUTION! Contact IKEA if any parts are missing or damaged.

Tools Required

• Phillips screwdriver: For all screw connections.
• Hammer: For inserting wall plugs.
• Drill: For making pilot holes in wall.
• Level: To ensure cabinet is mounted straight.
• Pencil: For marking wall.
• Tape measure: For accurate positioning.
• Stud finder (recommended): To locate wall studs.

Assembly Instructions

Assemble cabinet on soft surface to avoid scratches.

1. Lay back panel flat on protected surface.
2. Attach side panels to back panel using cam locks (follow diagram).
3. Attach top and bottom panels to side panels using provided screws.
4. Insert shelf pins at desired heights on both side panels.
5. Place shelves on pins.
6. Attach door to hinges on side panel (right or left opening as preferred).
7. Adjust door alignment using hinge screws if necessary.

Tip: Do not fully tighten screws until all parts are aligned.

Wall Mounting

Cabinet must be mounted to wall for safety.

1. Locate wall studs or use appropriate wall plugs for your wall type.
2. Hold cabinet against wall at desired height (recommended 150cm from floor to top).
3. Mark positions of mounting brackets on wall through back panel holes.
4. Drill pilot holes at marked positions.
5. Insert wall plugs (if not mounting into studs).
6. Screw mounting brackets securely to wall.
7. Hang cabinet on brackets and secure with provided screws through back panel.
8. Use level to ensure cabinet is straight.

WARNING! If not mounted into studs, use heavy-duty wall anchors suitable for your wall material and cabinet weight.

Adjusting Shelves

Shelves can be adjusted to different heights.

1. Remove items from shelf.
2. Lift shelf up and out of shelf pins.
3. Reposition shelf pins to desired height (pre-drilled holes every 5cm).
4. Place shelf back on pins.
5. Ensure shelf is level and secure.

Note: Distribute weight evenly across shelves. Do not place all heavy items on one shelf.

Care & Maintenance

Clean with damp cloth and mild detergent. Wipe dry immediately.

CAUTION! Do not use abrasive cleaners, scouring pads, or solvents. Avoid excessive moisture.

Weight Limits

Note: Exceeding weight limits may cause damage or cabinet failure.

Troubleshooting

Support: For missing parts or additional help, contact IKEA customer service or visit www.ikea.com.