IKEA OXBERG 690.204.73 Panel Door instructions manual

The IKEA OXBERG 690.204.73 is a panel door designed for use with compatible IKEA kitchen and wardrobe frames. It features a solid wood frame with a decorative panel insert, adjustable hinges for alignment, and a pre-drilled hole pattern for handle installation. Below are key sections for safety, parts list, assembly, installation, adjustment, care, and troubleshooting.

Parts and Tools Included

Key components: OXBERG door panel, hinge hardware pack, assembly instructions.

*Quantity depends on door height. Check packaging label.

Tools needed (not included): Phillips screwdriver, measuring tape, pencil, level.

Safety Information

Read all instructions before assembly and installation.

1. Work on a clean, flat, protected surface to avoid scratches.
2. Ensure the cabinet frame is securely fixed to the wall before attaching the door.
3. Use correct tools to prevent damage to screws and hinges.
4. Lift door with care; it is heavy. Use two people for larger doors.

WARNING! Improper installation can cause the door to fall, resulting in injury or damage. Ensure all screws are fully tightened and hinges are securely engaged.

Assembly Instructions

Attach hinges to the door panel before mounting to the frame.

1. Identify hinge placement: Mark positions according to template or frame hole pattern (typically 3-5 inches from top/bottom edges).
2. Attach hinges: Align hinge base plate with marked positions on door edge. Secure using provided screws. Do not overtighten.
3. Insert adjustment screws: Turn hinge adjustment screws to mid-position for initial installation.
4. Attach cover caps: Snap plastic caps onto hinge base plates for a finished look.

CAUTION! Ensure hinges are oriented correctly (cup towards door front).

Installation to Frame

Mount the assembled door onto the cabinet frame.

1. Align hinges: Hold door against frame so hinge arms align with mounting plates on frame.
2. Engage hinges: Push hinge arms onto mounting plates until they click into place.
3. Secure door: Tighten the locking screw on each hinge arm to fix door to frame.
4. Check operation: Open and close door to ensure smooth movement.

Tip: Have a helper support the door during alignment to prevent dropping.

Hinge Adjustment

Fine-tune door position using hinge adjustment screws.

Three-way adjustment:

• Height (Vertical): Turn the screw marked "UP/DOWN" to raise or lower the door relative to the frame.
• Depth (In/Out): Turn the screw marked "IN/OUT" to adjust the door's distance from the frame (for flush alignment).
• Side (Left/Right): Turn the screw marked "LEFT/RIGHT" to shift the door horizontally.

Make small adjustments (quarter turns) and check fit after each turn. Aim for even gaps (approx. 2-3mm) around the door.

Handle Installation

Install handle or knob on door front.

1. Select position: Mark desired handle location. Standard placement is vertical center on the door edge opposite hinges.
2. Drill holes: Use appropriate drill bit size as specified by handle manufacturer. Drill straight through door panel.
3. Attach handle: Insert fixing bolts through holes and secure with nuts or screws from the backside. Tighten firmly.

Note: Handle is not included with OXBERG door. Purchase separately.

Care & Maintenance

Clean with a soft, damp cloth. Wipe dry immediately. For stubborn stains, use mild soap solution. Do not use abrasive cleaners, scouring pads, or harsh chemicals.

CAUTION! Avoid excessive moisture. Do not soak or steam clean. Protect from direct heat sources.

Specifications

• Article Number: 690.204.73
• Type: Panel Door
• Material: Solid wood frame, Particleboard/foil panel
• Finish: White
• Dimensions (HxWxD): Varies by size - Check packaging label (e.g., 40x60 cm, 60x80 cm)
• Weight: Approximately 3-7 kg depending on size
• Compatible Systems: IKEA METOD, SEKTION kitchen frames; PAX wardrobe frames (with appropriate hinges)
• Hinge Type: IKEA standard concealed hinge (soft-closing optional)

Troubleshooting

Replacement Parts: Hinges and screws available at IKEA stores or via customer service.

Warranty & Support

IKEA limited warranty applies. See IKEA warranty terms for details. Retain your receipt as proof of purchase.

For assembly assistance, missing parts, or product support:

• Visit: www.ikea.com
• Contact IKEA Customer Support: 1-888-888-4532
• Visit your local IKEA store.

© Inter IKEA Systems B.V. 2025. OXBERG is a trademark of Inter IKEA Systems B.V.