IKEA NYMÅNE 604.247.94 Ceiling Lights instructions manual

The IKEA NYMÅNE 604.247.94 is a ceiling-mounted LED light fixture designed for indoor use. It features a minimalist design, energy-efficient LED light source, dimmable functionality (with compatible dimmers), and a white finish. This manual covers safety instructions, product overview, installation steps, operation, maintenance, and troubleshooting. Always read all instructions before installation and use.

1. Safety Information 2. Product Overview & Contents 3. Tools Required 4. Installation Instructions 5. Specifications 6. Operation & Dimming 7. Care & Maintenance 8. Troubleshooting 9. Warranty & Support

Safety Information

Read all safety instructions before installation and use. Failure to follow instructions may result in electric shock, fire, or injury.

Symbol/Note	Meaning
WARNING!	Risk of electric shock. Disconnect power at circuit breaker before installation.
CAUTION!	Risk of injury. Ensure mounting surface is sturdy and can support fixture weight.
NOTE	For indoor use only. Not suitable for bathrooms or other wet locations.
ATTENTION	LED module is non-replaceable. If light fails, the entire unit must be replaced.

IMPORTANT: Installation should be performed by a qualified electrician in accordance with local electrical codes.

Product Overview & Contents

Package includes all necessary parts for installation. Check contents before starting.

Main Fixture Body: White, ceiling-mounted unit with integrated LEDs.
Mounting Bracket: For securing the fixture to the ceiling.
Screws & Wall Plugs: For mounting bracket installation.
Wire Connectors (Wire Nuts): For electrical connections.
Instruction Manual (this document).

Verify Contents: Ensure all parts are present and undamaged before proceeding. Contact IKEA if any parts are missing.

Tools Required

Phillips screwdriver
Drill (if mounting to concrete ceiling)
Drill bit (size as needed for wall plugs)
Wire stripper/cutter
Voltage tester (non-contact recommended)
Stepladder

Tip: Have all tools ready before starting to ensure a smooth installation process.

Installation Instructions

STEP 1: TURN OFF POWER. Go to your home's electrical panel and turn off the circuit breaker that controls the ceiling light's power. Use a voltage tester to confirm power is off at the installation point.

STEP 2: MOUNT THE BRACKET.

Hold the mounting bracket against the ceiling junction box.
Mark the screw holes.
If needed, drill pilot holes and insert wall plugs.
Secure the bracket to the junction box using the provided screws. Ensure it is tight and level.

STEP 3: CONNECT WIRES.

Connect the fixture wires to the house wires using the wire connectors:
- Fixture Black (or Brown) wire → House Black (Live/Hot) wire.
- Fixture White (or Blue) wire → House White (Neutral) wire.
- Fixture Green/Yellow (Ground) wire → House Green/Bare Copper (Ground) wire.
Twist connectors clockwise until secure. Tuck wires neatly into the junction box.

STEP 4: ATTACH THE FIXTURE.

Align the fixture with the mounting bracket.
Rotate the fixture clockwise or secure with the provided locking screws (as per model design) until it is firmly attached to the bracket and ceiling.

STEP 5: RESTORE POWER & TEST. Turn the circuit breaker back on. Operate the wall switch to test the light.

WARNING! Do not energize the circuit until the fixture is fully installed and all connections are secure and insulated.

Specifications

Model: NYMÅNE 604.247.94
Light Source: Integrated, non-replaceable LED
Power Consumption: [e.g., 15W] (Check product label for exact value)
Lumen Output: [e.g., 1400 lm]
Color Temperature: [e.g., 2700K Warm White]
Dimmable: Yes, with leading-edge (TRIAC) or trailing-edge (ELV) dimmers (check compatibility)
Input Voltage: 120V AC, 60Hz
Dimensions: [e.g., Diameter: 12 inches, Height: 3 inches]
Weight: [e.g., 2.2 lbs]
IP Rating: IP20 (For dry indoor locations only)
Estimated Lifetime: [e.g., 25,000 hours]

Operation & Dimming

The light is operated by a standard wall switch. For dimming functionality:

Compatible Dimmer: Use only a dimmer switch rated for use with LED loads and compatible with integrated LED fixtures. Refer to the dimmer manufacturer's specifications.
Installation: The dimmer must be installed by a qualified electrician, replacing the standard wall switch.
Operation: Turn the dimmer knob or slide the control to adjust brightness.
Flickering/Buzzing: If flickering or buzzing occurs, the dimmer may be incompatible. Try adjusting the dimmer's low-end trim setting or consult the dimmer manual.

NOTE: Not all dimmers work with all LED fixtures. Incompatibility is the most common cause of operational issues.

Care & Maintenance

Cleaning:

Turn off power and allow the fixture to cool completely.
Use a soft, dry or slightly damp cloth to wipe the surface. Do not use abrasive cleaners, solvents, or chemical sprays.
Ensure no moisture enters any openings or the electrical compartment.

Maintenance: The LED module is integrated and cannot be serviced or replaced. If the light fails, the entire fixture must be replaced.

CAUTION! Never immerse the fixture in water or other liquids. Do not clean with pressure washers.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Light does not turn on	Power off; faulty connection; switch issue	Check circuit breaker; ensure wall switch is on; verify all wire connections are secure.
Light flickers	Incompatible dimmer; loose connection	Use a compatible LED dimmer; check and tighten all wire connections, especially at the fixture and switch.
Dimming not smooth or limited range	Dimmer incompatibility	Adjust dimmer's low-end trim (if available); replace with a dimmer certified for your specific LED fixture.
Buzzing sound from fixture or dimmer	Incompatible dimmer; electrical issue	Replace with a compatible dimmer. If problem persists, consult an electrician.
Light turns on by itself or behaves erratically	Smart home interference; faulty dimmer/switch	If connected to a smart system, check its settings. Try replacing the dimmer/switch with a standard one to isolate the issue.

Reset: For smart/dimmable versions, try turning power off at the breaker for 30 seconds, then restore.

Warranty & Support

This IKEA product is covered by a limited warranty. Refer to the IKEA warranty document included with your purchase or available at IKEA stores for full terms, conditions, and duration.

For Customer Support:

Visit: www.ikea.com
Contact your local IKEA store.
Refer to your sales receipt for model and purchase details when seeking support.

Recycling: At end of life, do not dispose of with household waste. Recycle according to local regulations for electronic waste (WEEE).