The IKEA MILSBO 204.523.07 is a glass-door cabinet designed for display and storage, featuring a metal frame, tempered glass panels, adjustable shelves, interior lighting capability, and a lockable door. It is designed for easy assembly with included hardware and tools. Below are key sections for safety, parts list, assembly, installation, use, care, and troubleshooting.
Before assembly, verify all parts are present. Key components: Metal frame panels, Tempered glass doors and side panels, Adjustable shelves, Hinges, Lock and key, Mounting hardware pack.
| Part Number | Description | Quantity |
|---|---|---|
| A1 | Main metal frame (Back) | 1 |
| A2 | Main metal frame (Side Left) | 1 |
| A3 | Main metal frame (Side Right) | 1 |
| B1 | Tempered glass door | 1 |
| B2 | Tempered glass side panel | 2 |
| C1 | Adjustable glass shelf | 3 |
| D1 | Door hinge set | 2 |
| E1 | Lock and key set | 1 |
| F1 | Hardware pack (screws, dowels, Allen key) | 1 |
Read all instructions before assembly. Ensure a safe workspace.
WARNING! Failure to secure cabinet to wall can result in serious injury or death from tipping.
Follow steps in order. Allow 60-90 minutes for assembly.
Tip: Do not fully tighten all screws until the entire frame is squared up.
Adjusting Shelves: Shelves are adjustable. Remove items, lift shelf up and out. Reposition support pins to desired height and replace shelf.
Locking: Turn key to lock/unlock. Keep keys in a safe place.
Display Tips: For best display, use with interior lighting. Do not exceed the maximum weight limit per shelf.
Door Adjustment: If door sags or doesn't close evenly, use the Allen key to adjust the screws on the hinges. Turn clockwise to raise the door, counterclockwise to lower it.
Designed for use with IKEA DIODER LED strip (not included).
CAUTION! Use only low-voltage LED lighting intended for interior use. Do not overload electrical circuits.
Glass: Clean with a soft, lint-free cloth dampened with a mild glass cleaner or a solution of vinegar and water. Dry thoroughly. Do not use abrasive cleaners.
Metal Frame: Wipe with a soft, damp cloth. Dry immediately. For stubborn marks, use a mild soap solution.
Moving: Always empty the cabinet before moving. Remove shelves and door if possible. Lift from the bottom frame, not the glass or shelves.
CAUTION! Never use scouring pads, abrasive cleaners, or harsh chemicals on glass or metal surfaces.
IKEA limited warranty applies. Refer to your IKEA warranty document for specific terms and duration.
For missing parts, assembly help, or other support:
This product is covered by copyright and design rights owned by Inter IKEA Systems B.V.
| Issue | Possible Cause | Solution |
|---|---|---|
| Door does not close evenly | Hinges need adjustment; frame not square | Adjust hinge screws; check that all frame screws are tight and frame is square. |
| Shelves wobble or seem unstable | Support pins not fully inserted; weight limit exceeded | Ensure pins are pushed all the way into holes. Remove excess weight from shelf. |
| Cabinet rocks or is unlevel | Floor uneven; feet not adjusted | Use a spirit level. Turn the adjustable feet at the base to stabilize. |
| Glass door is difficult to open/close | Hinges too tight; misaligned | Loosen hinge screws slightly, realign door, then re-tighten. |
| Key turns but lock doesn't engage | Lock mechanism not installed correctly | Disassemble lock area per instructions and ensure the locking bolt is aligned with the strike plate on the frame. |
Important: If any glass component is cracked or broken, discontinue use immediately and contact IKEA for a replacement part. Do not attempt to repair broken tempered glass.