The IKEA MALM 103.604.69 is a 6-drawer dresser from the MALM series, featuring a clean, modern design with smooth-running drawers, a sturdy particleboard and fiberboard construction with foil and acrylic paint finish, and a choice of color options. It requires assembly and must be securely anchored to the wall to prevent tip-over. Below are key sections for safety, parts list, assembly instructions, care, and warranty information.
Key safety points: The dresser is heavy and can tip over, causing serious or fatal injury. Secure it to the wall using the included tip-over restraint device.
| Warning | Description |
|---|---|
| TIP-OVER HAZARD | Unsecured dressers can tip over. Always use wall attachment. |
| CHILD SAFETY | Do not let children climb or hang on drawers or furniture. |
| ASSEMBLY | Assemble on a soft, clean surface to avoid scratches. Use correct tools. |
| WEIGHT LIMIT | Do not exceed drawer weight limits. Distribute weight evenly. |
| MOVING | Empty all drawers before moving the dresser. Lift with help. |
Check that all parts are included before starting assembly. Contact IKEA if any parts are missing.
IMPORTANT! Keep small parts away from children. Do not discard hardware until assembly is complete.
Follow steps in order. Allow 60-90 minutes for assembly. Two people recommended.
CAUTION! Do not overtighten screws in particleboard. Assemble on a carpet or blanket to prevent surface damage.
This is the most important step to prevent tip-over accidents.
WARNING! Never skip this step, even on carpeted floors. Check anchoring annually and after moving the dresser.
Drawers use a roller glide system for smooth operation.
Clean with a damp cloth wrung out in mild soapy water, then wipe dry.
DO NOT use abrasive cleaners, scouring pads, or solvents. Avoid excessive moisture.
To maintain drawer smoothness, occasionally clean the glides with a dry cloth and apply a small amount of furniture wax or silicone spray to the runners if they become stiff.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Drawer sticks or is hard to open | Misaligned glides, overloaded, dirty runners | Realign drawer, remove some weight, clean and lightly lubricate runners. |
| Dresser wobbles | Uneven floor, loose frame connections, not anchored | Adjust leveling (if applicable), tighten all cam locks and screws, ensure wall anchor is secure. |
| Drawer front is uneven | Drawer not fully inserted or glide height misadjusted | Remove and reinsert drawer, adjust the height screw on the glide. |
| Cam lock won't tighten | Cam or pin not aligned correctly | Disassemble the joint, ensure the pin is fully inserted into the cam, then retighten. |
| Scratches on surface | Assembly on hard surface, abrasive cleaning | Use touch-up paint (available from IKEA); assemble on soft surface in future. |
IKEA limited warranty applies. See IKEA terms and conditions for details.
For Missing Parts or Assembly Help: Contact IKEA Customer Service or visit the IKEA store where the product was purchased.
Online Resources: Assembly video and guide available at www.ikea.com. Search for article number 103.604.69.
Safety Recall Information: Register your product at IKEA website to receive safety notices.
Important: This furniture must be permanently attached to the wall with the included restraining device.