IKEA MACKAPÄR 103.347.53 Storage Unit instructions manual

The IKEA MACKAPÄR 103.347.53 is a versatile storage unit designed for home organization, featuring a modern design, durable construction, and adjustable shelves. This manual provides essential information for safe assembly, installation, use, maintenance, and troubleshooting of your storage unit. Please read all instructions carefully before beginning assembly.

Package Contents & Tools Required

Before starting, verify all parts are included and undamaged.

Tools you will need: Phillips screwdriver, hammer (for optional wall attachment). All other tools are included.

Safety Information

Your safety is important. Please follow these guidelines.

1. Assembly Surface: Assemble on a soft, clean surface (e.g., carpet, blanket) to prevent scratching.
2. Lifting: The unit is heavy. Use two people for lifting and moving to avoid injury.
3. Children: Keep children and pets away from the assembly area. Small parts are a choking hazard.
4. Stability: To prevent tipping, the storage unit MUST be securely attached to the wall using the provided wall attachment device, especially if children are present.
5. Weight Limit: Do not exceed the maximum load capacity of 55 lbs (25 kg) per shelf.

WARNING! Serious or fatal crushing injuries can occur from furniture tip-over. ALWAYS secure this furniture to the wall.

Assembly Instructions

Follow the steps in numerical order as shown in the included pictorial guide.

1. Step 1 - Prepare Parts: Lay out all panels and hardware. Identify each part using the diagrams.
2. Step 2 - Attach Side Panels to Base: Insert cam lock dowels into the base panel. Align the side panels and twist the cam locks clockwise to lock (listen for a click).
3. Step 3 - Install Fixed Shelf: Slot the fixed shelf into the pre-determined position between the side panels. Secure with provided screws from the outside.
4. Step 4 - Attach Back Panel: Place the unit face down on a protected surface. Align the back panel and secure it using the short screws provided. This adds structural rigidity.
5. Step 5 - Attach Top Panel: Place the top panel onto the side panels. Secure it using cam locks from underneath or screws as indicated.
6. Step 6 - Install Adjustable Shelves: Insert shelf support pins into the desired holes on the side panels. Gently place the adjustable shelves onto the pins.
7. Step 7 - Final Check: Ensure all screws and cam locks are fully tightened. Gently rock the unit to check for stability before proceeding to wall attachment.

Tip: Do not fully tighten all screws until the entire frame is assembled to allow for minor adjustments.

Installation & Placement

Proper placement ensures safety and longevity.

1. Choosing a Location: Place the unit on a flat, level, and solid floor. Avoid uneven surfaces.
2. Wall Attachment (CRITICAL):
   • Locate solid wall studs using a stud finder.
   • Position the unit against the wall in its final location.
   • Use the provided wall attachment bracket. Screw one part to the wall stud(s) and the other part to the top back of the storage unit.
   • Tighten securely. The unit should not be able to tilt forward.
3. Clearance: Allow at least 2 inches (5 cm) of clearance from heat sources like radiators or heaters.
4. Loading: Place heavier items on the lower shelves to maintain a low center of gravity.

Adjusting Shelves

The unit features flexible storage options.

• Adjustable Shelves: To move a shelf, lift it straight up and off the support pins. Reposition the pins in the desired set of holes on the inner side panels, then lower the shelf onto the new pins.
• Pin Placement: Ensure pins are inserted fully and evenly on both sides so the shelf sits level.
• Weight Distribution: Distribute weight evenly across the shelf to prevent sagging.

CAUTION! Empty the shelf before adjusting it. Do not stand or sit on the shelves.

Care & Maintenance

Proper care will keep your storage unit looking new.

1. Cleaning: Wipe surfaces with a soft, slightly damp cloth. Wipe dry immediately. For stubborn marks, use a mild soap solution. Do not use abrasive cleaners, scouring pads, or solvents.
2. Protection: Use coasters under glasses and placemats under hot dishes to prevent heat marks and stains.
3. Inspection: Periodically check the tightness of screws and cam locks, especially after moving the unit. Re-tighten if necessary.
4. Relocation: To move the unit, first remove all items and shelves. Disconnect it from the wall. Use two people to lift and carry it—do not drag.

Specifications

• Product Name: MACKAPÄR
• Article Number: 103.347.53
• Color: White
• Dimensions (W x H x D): 31.5" x 72" x 15.75" (80 cm x 183 cm x 40 cm)
• Weight: 55 lbs (25 kg)
• Max. Load per Shelf: 55 lbs (25 kg)
• Material: Particleboard, Fiberboard, Plastic, Steel
• Finish: Foil, Acrylic paint
• Adjustable Shelves: 2 pcs
• Fixed Shelves: 1 pc

Troubleshooting

Warranty & Support

This IKEA product is covered by a limited warranty. Refer to the IKEA warranty document included in the packaging for full terms and conditions.

Need Help?

• Assembly Support: Visit the product page at www.ikea.com and enter the article number (103.347.53) to access digital assembly instructions and videos.
• Missing Parts: Contact your local IKEA store or the IKEA customer support center with your article number and proof of purchase.
• IKEA Customer Service: Visit www.ikea.com or call 1-888-888-4532 for your region's contact details.

Recycling: At the end of its life, please disassemble and recycle the materials according to your local regulations.