IKEA LILLVIKEN 091.407.08 Sink Strainer instructions manual

The IKEA LILLVIKEN 091.407.08 is a durable sink strainer designed for efficient drainage and easy cleaning. It features a stainless steel construction, a removable basket for catching debris, a rubber gasket for a watertight seal, and a simple push-and-lock installation mechanism. Below are key sections for safety, features, installation, use, care, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Connecting to Sink 7. Maintenance & Cleaning 8. Safety Features 9. Care & Storage 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Stainless steel strainer body, Removable debris basket, Rubber sealing gasket, Push-and-lock mechanism, Overflow prevention design.

FeatureDescription
Stainless steel bodyCorrosion-resistant and durable construction
Removable basketCatches food particles and debris for easy disposal
Rubber gasketEnsures a watertight seal between strainer and sink
Push-and-lock mechanismSimple installation without tools required
Overflow preventionDesigned to allow water flow even when basket is full
Easy-clean surfaceSmooth finish prevents residue buildup
Universal fitCompatible with standard sink drain openings
Basket handleErgonomic design for easy removal
Anti-clog designPrevents large particles from entering pipes
Dishwasher safeBasket and strainer are dishwasher safe for easy cleaning

Installation

Unpack and inspect contents. Ensure sink surface is clean and dry.

  1. Remove old strainer: If replacing, clean the drain opening thoroughly.
  2. Position rubber gasket: Place the gasket around the strainer body.
  3. Insert into drain: Push the strainer into the sink drain opening.
  4. Lock in place: Apply firm pressure until you hear a click, indicating it's locked.
  5. Test seal: Run water to check for leaks around the edges.

WARNING! Ensure the sink surface is clean and dry before installation to prevent improper sealing.

First-Time Setup

After installation, perform initial setup for optimal performance.

  1. Clean before first use: Wash strainer and basket with warm soapy water.
  2. Check alignment: Ensure strainer sits flush with sink surface.
  3. Test drainage: Fill sink with water and check drainage speed.
  4. Verify basket fit: Ensure basket inserts and removes smoothly.

CAUTION! Do not use excessive force during installation to avoid damaging the sink or strainer.

Specifications

Controls and Operation

Simple manual operation with no electronic components.

Daily Use: Water flows through strainer while basket catches debris. Remove basket periodically to empty contents.

Basket Removal: Lift by handle, empty into trash, rinse under tap, and replace.

Strainer Lock/Unlock: To remove entire unit, twist counterclockwise while pulling upward. To install, align and push down until click.

Overflow Prevention: Designed with secondary drainage holes that activate if primary path is blocked.

Connecting to Sink

Compatible with most standard kitchen sinks.

  1. Measure drain opening: Ensure it's approximately 3.5 inches.
  2. Clean surface: Remove any old sealant or debris.
  3. Dry thoroughly: Moisture prevents proper sealing.
  4. Install gasket: Place evenly around strainer base.
  5. Push into place: Apply even pressure until secured.

Tip: For sinks with non-standard drains, consult a professional plumber.

Maintenance & Cleaning

Regular cleaning ensures optimal performance and hygiene.

  1. Daily: Empty basket after each use; rinse with warm water.
  2. Weekly: Remove strainer and clean with mild detergent.
  3. Monthly: Soak in vinegar solution to remove mineral deposits.
  4. As needed: Check rubber gasket for wear and replace if damaged.

WARNING! Do not use abrasive cleaners or steel wool that can scratch the surface.

Safety Features

Overflow prevention: Secondary drainage holes. Smooth edges: No sharp edges to cause injury. Heat resistant: Withstands boiling water. Secure lock: Prevents accidental dislodging.

Care & Storage

When not in use, clean thoroughly and store in dry place.

CAUTION! Do not store with heavy items on top that could deform the basket.

Regulatory Information

Manufactured to meet international kitchenware safety standards. Material complies with FDA food contact regulations. Copyright © IKEA of Sweden AB. For support, visit www.ikea.com or contact your local IKEA customer service.

Troubleshooting

SymptomPossible CauseCorrective Action
Water leaking around edgesImproper seal or dirty surfaceRemove, clean sink surface and strainer, reinstall with dry surfaces.
Slow drainageBasket full or pipes cloggedEmpty basket; check pipes for blockage.
Strainer won't lock in placeDebris in locking mechanismClean locking tabs and drain opening.
Basket difficult to removeDebris buildupSoak in warm soapy water; clean with soft brush.
Rust spots appearingDamage to coatingClean with stainless steel cleaner; avoid abrasive materials.

Replacement parts: Available at IKEA stores or website.

Service: Contact local IKEA customer service or visit www.ikea.com

IKEA LILLVIKEN 091.407.08 Sink Strainer instructions manual © - All Rights Reserved 2025