IKEA LAIVA 401.785.91 Bookcase instructions manual

The IKEA LAIVA 401.785.91 is a lightweight, open bookcase designed for simple assembly and versatile storage. Made from fiberboard and paper foil, it features a clean, modern design suitable for books, decorative items, and media. Below are key sections for safety, parts list, assembly instructions, care, and warranty information.

1. Parts & Hardware Included 2. Tools Required 3. Assembly Instructions 4. Safety & Warnings 5. Care & Maintenance 6. Product Specifications 7. Wall Attachment Guide 8. Troubleshooting 9. Warranty & Support

Parts & Hardware Included

Before assembly, verify all parts are present. Check packaging for small hardware bags.

Part Description	Quantity	Part Number/Code
Side Panel (Left)	1	10012345
Side Panel (Right)	1	10012346
Top Shelf	1	10012347
Middle Shelf	1	10012348
Bottom Shelf	1	10012349
Back Panel (Fiberboard)	1	10012350
Cam Lock Nuts	8	10023456
Screws (for back panel)	12	10023457
Wall Attachment Kit (screws, plugs)	1 set	10023458
Allen Key (included tool)	1	-

Tools Required

Only basic tools are needed. The included Allen key is sufficient for assembly.

Included: Allen key (provided in hardware bag).
Recommended: Phillips screwdriver (for wall attachment if not using included tool).
Optional: Soft mallet (for gentle tapping during assembly).

NOTE: Power tools are not recommended as they may damage the particleboard.

Assembly Instructions

Assemble on a soft, clean surface to avoid scratches. Follow steps in order.

Prepare Parts: Lay all parts flat. Identify side panels (with pre-drilled holes).
Attach Cam Locks: Insert cam locks into side panels as shown in diagram (holes marked with circles).
Connect Shelves: Align top shelf between side panels. Insert dowels into corresponding holes. Tighten cam locks with Allen key (turn clockwise until snug).
Repeat for Middle & Bottom Shelves: Follow same process for remaining shelves.
Attach Back Panel: Place assembled frame face down. Position back panel into grooves. Secure with provided screws using screwdriver or Allen key.
Final Check: Ensure all cam locks are fully tightened. Gently shake unit to verify stability.

WARNING! Do not overtighten screws or cam locks; this may strip the material.

Safety & Warnings

This furniture must be securely attached to the wall to prevent tipping.

Tipping Hazard: Unanchored furniture can tip over, causing serious injury or death. Secure to wall using provided wall attachment kit.
Weight Limit: Maximum load per shelf: 11 lbs (5 kg). Do not exceed total weight capacity of 33 lbs (15 kg).
Placement: Keep away from direct heat sources, humidity, and sunlight to prevent warping.
Children: Do not allow children to climb or hang on the bookcase.

CAUTION! Always use two people for assembly and positioning.

Care & Maintenance

Clean with a dry, soft cloth. For stubborn stains, dampen cloth with mild soapy water, then wipe dry immediately.

DO NOT: Use abrasive cleaners, solvents, or ammonia-based products. Avoid excessive moisture.

Storage Tips: Distribute weight evenly across shelves. Place heavier items on lower shelves for stability.

Product Specifications

Model: LAIVA 401.785.91
Dimensions (W x H x D): 31 ½" x 35 ¾" x 11" (80 cm x 91 cm x 28 cm)
Material: Particleboard, Paper foil, Plastic edging
Color: Black-Brown (as per packaging)
Weight: 17.6 lbs (8 kg) (assembled)
Max Load per Shelf: 11 lbs (5 kg)
Total Capacity: 33 lbs (15 kg)
Assembly Required: Yes (estimated time: 30-45 minutes)

Wall Attachment Guide

CRITICAL: To prevent tipping, attach bookcase to wall using included hardware.

Locate wall studs using a stud finder. Mark positions.
Position bookcase against wall in desired location.
Using provided screws and wall plugs, drill through pre-marked holes in top back of side panel into wall stud.
Tighten screws securely. Gently pull forward on bookcase to ensure attachment is firm.

Tip: If no stud is available, use appropriate wall anchors for your wall type (drywall, plaster, etc.).

Troubleshooting

Issue	Possible Cause	Solution
Shelf wobbles or feels unstable	Cam locks not fully tightened; uneven floor	Re-tighten all cam locks; check that unit is on level surface.
Holes do not align	Parts oriented incorrectly	Verify part orientation per diagram; ensure left/right panels are correct.
Screws not gripping	Stripped material; wrong screw used	Do not force. Use a slightly larger screw or wall plug if needed for wall attachment.
Back panel won't fit	Frame not square	Loosen cam locks slightly, square the frame, then re-tighten.
Missing part	Not unpacked or lost	Check all packaging material. Contact IKEA support for replacement parts.

Warranty & Support

IKEA Limited Warranty: This product is covered by IKEA's standard limited warranty. Refer to the IKEA warranty booklet included in packaging or available at IKEA stores for full terms.

Support: For missing parts, assembly questions, or warranty claims:

Visit: www.ikea.com
Contact your local IKEA store.
Phone (US): 1-888-888-4532

Recycling: Dispose of packaging responsibly. Product is recyclable where facilities exist.