IKEA KULLEN 404.847.84 6 Drawer Dresser instructions manual

The IKEA KULLEN 404.847.84 is a 6-drawer dresser designed for bedroom storage, featuring a sturdy construction, smooth-gliding drawers, and a modern design. It requires assembly and includes all necessary hardware. Below are key sections for safety, parts list, assembly instructions, care, and troubleshooting.

1. Parts & Hardware Included 2. Safety Instructions 3. Assembly Instructions 4. Specifications 5. Drawer Installation & Adjustment 6. Wall Attachment 7. Care & Maintenance 8. Troubleshooting 9. Warranty & Support

Parts & Hardware Included

Before assembly, verify all parts are present. Key components: Dresser frame panels, 6 drawer fronts, 6 drawer boxes, drawer runners, back panel, screws, cam locks, dowels, wall attachment device.

Part Description	Quantity	Image Ref
Dresser side panel	2	A
Dresser top panel	1	B
Dresser bottom panel	1	C
Drawer front (various sizes)	6	D
Drawer box	6	E
Drawer runner set	6 pairs	F
Back panel	1	G
Cam lock screws	12	H
Dowel pins	16	I
Wall attachment device	1 set	J

Safety Instructions

Read all instructions before assembly. Use on stable, level floor.

Tip-over prevention: Always secure dresser to wall using provided wall attachment device.
Weight capacity: Do not exceed drawer weight limits. Distribute weight evenly.
Assembly: Use two people for lifting and assembly. Keep small parts away from children.
Tools: Use correct tools (included Allen key). Do not overtighten screws.

WARNING! Serious or fatal crushing injuries can occur from furniture tip-over. Always secure furniture to wall.

Assembly Instructions

Follow steps in order. Allow 60-90 minutes for assembly.

Prepare workspace: Lay soft cloth on floor to prevent scratches.
Assemble frame: Connect side panels to top and bottom using dowels and cam locks. Tighten cam locks clockwise.
Attach back panel: Place back panel into grooves on frame. Secure with provided screws.
Install drawer runners: Attach runner halves to dresser sides and drawer boxes as shown in diagram.
Attach drawer fronts: After inserting drawer boxes, align and attach fronts to drawer boxes using screws from inside.
Final check: Ensure all cam locks are tight, drawers open and close smoothly.

Tip: Do not fully tighten cam locks until all parts are aligned.

Specifications

Product Name: KULLEN
Article Number: 404.847.84
Dimensions (W x H x D): 31 1/2" x 47 1/4" x 18 1/8" (80 x 120 x 46 cm)
Drawer interior dimensions: Varies by drawer (see packaging)
Max load per drawer: 22 lbs (10 kg)
Material: Particleboard, Fiberboard, Plastic, Steel
Finish: White stain, Ash veneer
Weight: 77 lbs (35 kg) unpacked
Tools required: Allen key (included)

Drawer Installation & Adjustment

Drawers use full-extension runners for smooth operation.

Insert drawer runner halves into slots on dresser sides until they click.
Align drawer box runners with dresser runners and push in until fully engaged.
If drawer is uneven, adjust by loosening screws on runner and repositioning.
Attach drawer front: Open drawer, align front with frame, secure from inside with screws.

Note: Drawers are removable for cleaning. Pull drawer fully out, lift slightly, and pull to release.

Wall Attachment

CRITICAL STEP: To prevent tip-over, dresser must be anchored to wall.

Locate wall studs using stud finder.
Position dresser against wall where it will be used.
Attach wall bracket to dresser back panel using provided screws.
Mark hole locations on wall through bracket. Drill pilot holes into studs.
Secure bracket to wall with screws (not included for all wall types).
Check stability by gently pulling top of dresser forward.

WARNING! If not properly secured, dresser can tip over and cause serious injury. Use appropriate wall fasteners for your wall type (drywall, plaster, masonry).

Care & Maintenance

Clean with damp cloth and mild detergent. Wipe dry immediately.

Surfaces: Use soft cloth. Avoid abrasive cleaners, solvents, or waxes.
Drawers: Remove contents and wipe interior with dry cloth.
Runners: Periodically clean runners with dry cloth to remove dust.
Avoid: Direct sunlight, heat sources, and high humidity.

CAUTION! Do not sit or stand on dresser. Do not place TV or heavy objects on top.

Troubleshooting

Issue	Possible Cause	Solution
Drawer sticks or won't close	Runner misaligned or obstructed	Remove drawer, check for obstructions, realign runner.
Dresser wobbles	Uneven floor or loose joints	Adjust floor levelers (if present); tighten all cam locks and screws.
Drawer front uneven	Mounting screws loose	Loosen screws, align front, retighten from inside drawer.
Cam lock won't tighten	Dowel not fully inserted	Disassemble, ensure dowel is fully seated in hole, reassemble.
Missing part	Packaging error	Contact IKEA customer service with article number.

Warranty & Support

IKEA limited warranty applies. See IKEA warranty card for details.

For missing parts or assembly help: Visit IKEA store or contact IKEA customer service.

Online resources: Assembly video available at IKEA website under product support.

Contact: IKEA Customer Support: 1-888-888-4532 or www.ikea.com