IKEA KORNSJÖ 504.554.13 Shelf instructions manual

The IKEA KORNSJÖ 504.554.13 is a versatile wall-mounted shelf unit designed for storage and display. It features a clean, modern design with metal brackets and a wooden shelf board. Below are key sections for safety, parts list, assembly, installation, care, and warranty information.

1. Parts & Hardware 2. Tools Required 3. Safety Instructions 4. Assembly Steps 5. Wall Installation 6. Weight Limits & Usage 7. Care & Maintenance 8. Troubleshooting 9. Warranty & Support

Parts & Hardware

All components included in the package.

Part Name	Quantity	Description
Shelf board	1	Wooden board, pre-finished
Wall bracket (left)	1	Metal bracket with pre-drilled holes
Wall bracket (right)	1	Metal bracket with pre-drilled holes
Screw A (for bracket to wall)	4	Wall anchor screws
Screw B (for shelf to bracket)	4	Smaller screws with washers
Wall plugs	4	Plastic anchors for solid walls
Instruction manual	1	This document

Tools Required

Tools not included; you will need to provide these.

Phillips screwdriver (or cordless drill with Phillips bit)
Pencil
Level
Tape measure
Hammer (for inserting wall plugs)
Stud finder (recommended for locating wall studs)

NOTE: Using the correct tools ensures safe and proper assembly.

Safety Instructions

Read all instructions before beginning assembly and installation.

Work Area: Assemble on a clean, soft surface to avoid scratching the shelf.
Wall Type: Ensure your wall is suitable for the load. Use a stud finder to locate wooden studs for the most secure installation. For hollow walls (drywall), use the provided wall anchors and ensure they are properly seated.
Lifting: The shelf is lightweight, but use care when handling to avoid pinching fingers.
Installation Height: Install at a height safe for all users, considering what will be stored on the shelf.

WARNING! Incorrect installation can cause the shelf to fall, resulting in injury or damage. Always secure to a structurally sound wall.

Assembly Steps

Assemble the brackets and shelf before mounting to the wall.

Identify Parts: Lay out all parts from the package using the Parts & Hardware list.
Attach Brackets to Shelf: Place the shelf board upside down on a protected surface. Position the left and right brackets on the underside of the shelf, aligning the pre-drilled holes. Secure each bracket using 2 of the smaller Screw B with washers per bracket. Do not overtighten.
Check Alignment: Ensure both brackets are parallel and firmly attached to the shelf.

Tip: Keep the assembly upside down until you are ready to lift it onto the wall anchors.

Wall Installation

This is the most critical step for safety.

Plan Placement: Decide on the shelf's location. Use a stud finder to locate wall studs. Marking the bracket holes into studs is the strongest method.
Mark Bracket Holes: Hold the assembled shelf (with brackets attached) against the wall at the desired height. Use a level on top of the shelf board to ensure it is perfectly horizontal. Lightly mark the wall through the screw holes in each bracket. You will have 4 marks (2 per bracket).
Prepare Wall: If drilling into drywall (not a stud), use a drill bit slightly smaller than the wall plugs to drill holes at your marks. Gently tap the plastic wall plugs into the holes until flush with the wall.
Mount the Shelf: Align the bracket holes with the wall plugs or studs. Insert the larger Screw A through the bracket and into the wall plug or stud. Tighten securely but do not strip the screw head. Repeat for all four screws.
Final Check: Gently pull down on the shelf to test its stability. Ensure it is level and does not wobble.

CAUTION! If the wall material is uncertain (e.g., plaster, tile), consult a professional. The provided hardware is for standard solid walls and drywall.

Weight Limits & Usage

Max Load: 15 kg (33 lbs) evenly distributed.
Recommended Items: Books, decorative objects, small electronics, photo frames.
Not Recommended: Heavy appliances, aquariums, or use as a step stool.
Environmental: For indoor use only. Avoid placing in areas of high humidity (e.g., bathrooms) unless the room is well-ventilated.

Exceeding the weight limit can cause bracket failure or pull the anchors from the wall.

Care & Maintenance

To keep your shelf looking its best.

Cleaning: Wipe the wooden shelf with a dry or slightly damp cloth. Do not use abrasive cleaners, scouring pads, or chemical solvents.
Metal Brackets: Dust with a dry cloth. If needed, wipe with a damp cloth and dry immediately.
Inspection: Periodically check the tightness of the screws and the stability of the shelf on the wall.

CAUTION! Do not soak or spill liquids on the wooden shelf, as it may cause warping or finish damage.

Troubleshooting

Problem	Possible Cause	Solution
Shelf is not level	Wall markings were uneven; brackets not aligned during assembly.	Loosen screws slightly, adjust shelf with a level, and retighten. You may need to remount the brackets.
Shelf feels loose or wobbles	Screws are not tight; wall anchors are not secure; installed in unsuitable wall material.	Tighten all screws. If problem persists, remove shelf and install new, heavier-duty wall anchors suitable for your wall type.
Brackets are difficult to attach to shelf	Holes are misaligned.	Ensure you are using the correct screws (Screw B) and that the bracket is oriented correctly on the underside of the shelf.
Cannot find wall studs	Stud finder not working or studs are spaced widely.	Use the provided wall anchors for drywall installation, ensuring you follow the drilling instructions carefully. For heavy loads, consider a professional installation.

Warranty & Support

IKEA limited warranty applies. See IKEA terms and conditions for details.

Warranty Coverage: Covers material and manufacturing defects under normal home use for the specified period from the date of purchase. Proof of purchase is required.

Non-Coverage: Damage due to improper assembly, incorrect installation, modification, accidental damage, or use outside recommended guidelines (e.g., excess weight, outdoor use).

Support: For missing parts, assembly help, or warranty claims:

Visit: www.ikea.com
Contact your local IKEA store.
Refer to your purchase receipt for country-specific contact details.

Recycling: At end of life, disassemble and recycle materials according to your local regulations.