IKEA IKORNNES 003.069.20 Mirror instructions manual

The IKEA IKORNNES 003.069.20 is a wall-mounted mirror designed for bathroom or hallway use. It features a sturdy frame, safety backing, and hardware for secure installation. Below are key sections for safety, features, installation, care, and troubleshooting.

1. Features at a Glance 2. Package Contents 3. Safety Instructions 4. Installation Steps 5. Mounting Hardware 6. Care & Cleaning 7. Troubleshooting 8. Warranty & Support

Features at a Glance

Key components: Mirror glass, Frame, Wall mounting brackets, Screws and wall plugs.

Feature	Description
Frame material	Sturdy, moisture-resistant finish
Mirror type	Clear, silvered glass with protective backing
Mounting type	Wall-mounted, fixed position
Safety feature	Protective film on back to hold glass if broken
Intended use	Indoor use in dry or humid areas (e.g., bathroom)

Package Contents

Unpack and verify all parts before starting installation.

Mirror assembly (1 piece)
Wall brackets (2 pieces)
Screws (4 pieces)
Wall plugs (4 pieces)
Instruction manual (this document)

WARNING! Check for damage before installation. Do not use if glass is cracked or frame is damaged.

Safety Instructions

Read all instructions before installation.

Use appropriate wall type: Mount only on solid walls (concrete, brick, or sturdy studs).
Check weight capacity: Ensure wall can support mirror weight.
Keep away from children: Install at safe height to prevent tipping.
Use correct tools: Drill, level, screwdriver, pencil, tape measure.

CAUTION! Mirror is heavy; use two people for handling and installation.

Installation Steps

Step 1: Choose location: Ensure wall is flat, dry, and away from direct heat sources.
Step 2: Mark bracket positions: Use level to mark screw holes from template (if provided) or measure bracket spacing.
Step 3: Drill holes: Use drill bit size recommended for wall plugs.
Step 4: Insert wall plugs: Tap gently into holes.
Step 5: Attach brackets: Secure to wall with screws.
Step 6: Hang mirror: Lift mirror onto brackets; ensure it clicks into place.
Step 7: Final check: Verify mirror is level and securely mounted.

Mounting Hardware

Hardware included: Screws (4x), Wall plugs (4x), Brackets (2x).

Tools needed: Drill, Level, Screwdriver, Pencil, Tape measure, Safety glasses.

Wall requirements: Solid wall capable of supporting weight. Do not mount on plasterboard alone without proper anchors.

Care & Cleaning

Use soft, lint-free cloth. For smudges, dampen cloth with water or mild glass cleaner. Do not use abrasive cleaners, ammonia, or solvents.

Unplug if applicable (not applicable for this mirror).
Spray cleaner on cloth, not directly on mirror.
Wipe gently in circular motion; dry with clean cloth.

Tip: Avoid excessive moisture on frame edges to prevent damage.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Mirror not level	Uneven brackets/wall	Re-check level during installation; adjust brackets.
Brackets loose	Incorrect wall plugs/screws	Use appropriate anchors for wall type; tighten screws.
Glass appears cloudy	Protective film not removed	Remove any protective film from front and back.
Frame damage	Shipping/installation error	Contact IKEA for replacement if damaged.
Mirror slips off bracket	Not properly seated	Lift mirror and re-engage with bracket hooks securely.

Reset: If unstable, remove and reinstall following steps carefully.

Warranty & Support

IKEA limited warranty applies. For support, visit www.ikea.com or contact your local IKEA store. Keep receipt for warranty claims.

Safety Compliance: Meets applicable safety standards for glass products.