IKEA HÅRSLINGA 305.565.02 Floor Lamp instructions manual

The IKEA HÅRSLINGA 305.565.02 is a modern floor lamp featuring a tripod base, adjustable height, fabric shade, and an integrated LED light source. It provides ambient lighting suitable for living rooms, bedrooms, or reading corners. Below are key sections for safety, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Package Contents 3. Safety Instructions 4. Assembly Instructions 5. Specifications 6. Operation & Controls 7. Placement & Positioning 8. Care & Cleaning 9. Warranty Information 10. Troubleshooting

Features at a Glance

Key components: Tripod metal base, adjustable central pole, fabric shade, integrated non-replaceable LED module, touch-sensitive dimmer control.

FeatureDescription
Tripod BaseProvides stable support on various floor surfaces
Adjustable HeightCentral pole can be extended or retracted
Fabric ShadeDiffuses light for soft, ambient illumination
Integrated LEDEnergy-efficient, long-life light source (non-replaceable)
Touch DimmerLocated on the pole; touch to turn on/off and adjust brightness
Cable ManagementInternal routing for a clean appearance
Foot SwitchAlternative on/off control at the base

Package Contents

Unpack and verify all parts are present before assembly.

  1. Tripod base (3 legs)
  2. Central pole (2 sections)
  3. Fabric lamp shade
  4. Mounting hardware (screws, bolts)
  5. Instruction manual
  6. Power cord with plug

NOTE: Contact IKEA customer service if any part is missing or damaged.

Safety Instructions

Read all instructions before assembly and use.

  1. Ensure the lamp is placed on a stable, level surface.
  2. Do not use outdoors or in damp locations.
  3. Use only with the provided power cord.
  4. Do not attempt to replace the integrated LED light source.
  5. Keep away from children and pets to prevent tipping.
  6. Unplug before cleaning or maintenance.

WARNING! Risk of electric shock or fire if misused. Do not exceed recommended usage.

Assembly Instructions

Estimated assembly time: 15-20 minutes. Tools required: Phillips screwdriver (not included).

  1. Attach the three legs to the central hub using the provided bolts. Tighten securely.
  2. Insert the lower section of the central pole into the hub. Secure with the locking screw.
  3. Slide the upper pole section into the lower section. Adjust to desired height and tighten the height adjustment knob.
  4. Place the fabric shade over the top of the pole. Secure it using the included ring or clip mechanism.
  5. Route the power cord through the central pole and out the designated opening at the base.
  6. Plug the power cord into a standard 120V AC wall outlet.

CAUTION! Ensure all connections are tight to prevent wobbling. Do not overtighten screws.

Specifications

Operation & Controls

Touch Dimmer Control (on pole): Touch once to turn on. Touch and hold to dim up or down. Touch once to turn off.

Foot Switch (on base): Press to turn on/off. This overrides the touch control when used.

Height Adjustment: Loosen the knob on the pole, adjust height, then retighten.

Note: The lamp may have a slight warm-up time to reach full brightness.

Placement & Positioning

  1. Place the lamp on a firm, flat surface away from high-traffic areas.
  2. Ensure the tripod legs are fully extended for maximum stability.
  3. Position near a power outlet to avoid using extension cords.
  4. For reading, position the lamp so the light falls over your shoulder onto the reading material.
  5. For ambient lighting, place in a corner or beside furniture.

Tip: Avoid placing near heat sources or direct sunlight to prevent shade fading.

Care & Cleaning

Unplug the lamp before any cleaning.

  1. Shade: Use a soft brush or vacuum with a brush attachment to remove dust. Do not wash.
  2. Metal Parts: Wipe with a soft, dry cloth. For stubborn marks, use a damp cloth and mild detergent. Dry immediately.
  3. Do Not: Use abrasive cleaners, solvents, or immerse any part in water.

CAUTION! Never spray cleaning agents directly onto the lamp.

Warranty Information

This IKEA product is covered by a limited warranty. Refer to the IKEA warranty document included in the packaging or available at www.ikea.com.

Warranty typically covers defects in materials and workmanship under normal household use. The integrated LED light source is covered for a specific period (e.g., 25,000 hours or 3 years).

For warranty claims, contact IKEA customer service with your proof of purchase.

Troubleshooting

SymptomPossible CauseCorrective Action
Lamp does not turn onNot plugged in / Power outageCheck power cord connection and wall outlet. Try a different outlet.
Light flickersLoose connection / Faulty dimmerEnsure all assembly connections are tight. Try resetting by unplugging for 30 seconds.
Lamp is unstableLegs not fully extended / Uneven floorExtend all tripod legs fully. Place on a level surface.
Touch control unresponsiveDirty surface / Internal faultClean touch area with a dry cloth. Unplug and plug back in. If persistent, contact support.
Dimming not workingIncorrect operation / Faulty dimmer circuitTouch and hold for dimming. Ensure you are using the correct control area.

Service: For non-warranty service or spare parts, visit www.ikea.com or contact your local IKEA store.

Recycling: Dispose of this product according to local electronic waste regulations.

IKEA HÅRSLINGA 305.565.02 Floor Lamp instructions manual © - All Rights Reserved 2025