IKEA HEMNES 302.512.71 Wardrobe instructions manual

The IKEA HEMNES 302.512.71 is a classic, solid wood wardrobe offering ample storage with adjustable shelves, a clothes rail, and two doors. Designed for self-assembly, it requires careful unpacking, organization of parts, and step-by-step construction using the included Allen key. Below are key sections for safety, parts list, tools required, assembly instructions, mounting, adjustment, care, and troubleshooting.

1. Parts & Hardware Included 2. Tools Required 3. Safety Instructions 4. Assembly Steps 5. Mounting to Wall 6. Adjusting Doors & Shelves 7. Care & Maintenance 8. Specifications 9. Warranty Information 10. Troubleshooting

Parts & Hardware Included

Key components: Solid wood panels, doors, back panel, shelves, clothes rail, hinges, screws, dowels, cam locks, and wall attachment fittings.

Part NumberDescriptionQuantity
101Side panel (left)1
102Side panel (right)1
103Top panel1
104Bottom panel1
105Back panel (fiberboard)1
106Door (left)1
107Door (right)1
108Adjustable shelf2
109Clothes rail1
110Hinge set4
111Cam lock set8
112Dowel set12
113Screw set1 pack
114Wall attachment fittings2

Tools Required

Tools not included that you will need for assembly.

  1. Allen key (included in hardware pack).
  2. Phillips screwdriver.
  3. Hammer (for tapping dowels).
  4. Level (for checking alignment).
  5. Pencil (for marking).
  6. Drill (for wall mounting, if needed).

WARNING! Use correct tools to avoid damaging parts or injury.

Safety Instructions

Read all instructions before starting assembly.

  1. Work on a clean, flat, protected surface to avoid scratches.
  2. Assemble with at least two people—wardrobe is heavy.
  3. Keep small children and pets away from assembly area.
  4. Wear safety glasses if hammering or drilling.
  5. Ensure all screws and fittings are tightened securely.
  6. CRITICAL: Always secure wardrobe to wall to prevent tipping.

CAUTION! Heavy parts—lift with your legs, not your back.

Assembly Steps

Follow steps in numerical order as shown in included pictorial guide.

  1. Step 1: Lay side panels (101, 102) flat. Insert dowels into pre-drilled holes.
  2. Step 2: Attach bottom panel (104) to side panels using cam locks.
  3. Step 3: Attach top panel (103) in same manner.
  4. Step 4: Stand frame upright carefully with assistance.
  5. Step 5: Attach back panel (105) with provided screws—start from top center.
  6. Step 6: Insert clothes rail (109) into designated brackets.
  7. Step 7: Place adjustable shelves (108) on shelf pins at desired height.
  8. Step 8: Attach hinges to doors (106, 107), then mount doors to frame.
  9. Step 9: Adjust door alignment using hinge screws (see Section 6).
  10. Step 10: Install door handles (if included).

Tip: Do not fully tighten cam locks until all panels are aligned.

Mounting to Wall

This step is mandatory to prevent tipping hazard.

  1. Position wardrobe in its final location against wall.
  2. Locate wall studs using a stud finder.
  3. Mark drilling points through pre-drilled holes in top back panel.
  4. Drill pilot holes into wall studs.
  5. Secure wardrobe using provided wall attachment fittings (114) and suitable screws for your wall type.
  6. Check stability by gently pulling top forward.

WARNING! If not secured, wardrobe can tip over and cause serious injury or death.

Adjusting Doors & Shelves

Doors: Adjust vertically/horizontally via hinge screws. Shelves: Move shelf pins to desired height.

Door Alignment:

  1. Open door fully.
  2. Use Phillips screwdriver on hinge adjustment screws:
    • Top screw controls vertical alignment.
    • Side screw controls horizontal alignment (in/out).
  3. Close door to check fit; repeat until even gap is achieved.

Shelf Adjustment: Remove shelf, reposition metal pins in pre-drilled holes, replace shelf.

Care & Maintenance

Use a dry or slightly damp cloth to clean surfaces. For stubborn stains, use mild soap solution; dry immediately.

DO NOT: Use abrasive cleaners, scouring pads, solvents, or wax polishes.

Wood Care: Avoid direct sunlight and heat sources to prevent fading/warping. Maintain consistent humidity.

Specifications

Warranty Information

IKEA Limited Warranty: 10 years for structural components under normal domestic use. Proof of purchase required. Warranty does not cover damage from improper assembly, modification, accidents, or commercial use. For warranty claims, contact IKEA customer service with article number and receipt.

Troubleshooting

SymptomPossible CauseCorrective Action
Doors not closing evenlyHinges misalignedAdjust hinge screws (see Section 7).
Wardrobe wobblesFloor uneven / assembly looseCheck all cam locks and screws are tight; use shims under feet.
Shelves saggingOverloadedReduce weight to max 33 lbs (15 kg) per shelf.
Difficulty inserting dowelsMisaligned holesEnsure parts are correctly oriented; tap gently with hammer.
Back panel bulgingScrews not tight / panel upside downRe-tighten screws evenly from center out; check orientation marks.
Missing partsPackaging errorContact IKEA customer service with article number (302.512.71).

Re-tighten: Check all connections after 2 weeks as wood may settle.

Customer Support: IKEA US: 1-888-888-4532 | www.IKEA-usa.com

IKEA HEMNES 302.512.71 Wardrobe instructions manual © - All Rights Reserved 2025