IKEA HEMNES 104.971.70 Sink Cabinet instructions manual

The IKEA HEMNES 104.971.70 is a sink cabinet designed for bathroom installation, featuring a solid wood construction, water-resistant finish, integrated sink bowl (or preparation for one), adjustable legs, soft-closing doors/drawers, and necessary hardware for assembly. This manual covers safety, parts identification, step-by-step assembly, installation, care, and troubleshooting.

1. Parts & Hardware Included 2. Tools Required 3. Safety Instructions 4. Step-by-Step Assembly 5. Sink & Plumbing Installation 6. Adjustments & Leveling 7. Care & Maintenance 8. Specifications 9. Warranty Information 10. Troubleshooting

Parts & Hardware Included

Before assembly, verify all parts are present. Key components: Cabinet frame panels, doors/drawer fronts, back panel, adjustable legs, sink bowl (if included), hinges, drawer runners, screws, dowels, cam locks, and mounting brackets.

Part DescriptionQuantityIdentification Code
Cabinet side panel (left)1A
Cabinet side panel (right)1B
Cabinet top panel (with sink cutout)1C
Cabinet bottom panel1D
Back panel1E
Door front2F
Drawer front1G
Adjustable legs4H
Soft-closing hinge set6I
Drawer runner set2J

Note: Some parts may be pre-assembled. Check packaging for small hardware bags labeled with step numbers.

Tools Required

Not included; you will need:

Tip: A cordless screwdriver can speed up assembly but use low torque to avoid stripping screws.

Safety Instructions

WARNING! To prevent injury and damage:

  1. Work Area: Assemble on a clean, flat, protected surface to avoid scratching parts.
  2. Lifting: Cabinet is heavy; use two people for lifting and positioning.
  3. Children & Pets: Keep away from assembly area due to small parts and tools.
  4. Hardware: Keep small parts away from children to avoid choking hazard.
  5. Power Tools: Use caution; overtightening can split wood or strip screws.
  6. Installation: Ensure cabinet is securely anchored to wall if recommended, especially in earthquake-prone areas.

CAUTION! Do not stand on or place excessive weight on doors or drawers.

Step-by-Step Assembly

Follow steps in order. Allow 60-90 minutes for assembly.

  1. Prepare Parts: Lay out all panels as per illustration in manual. Identify hardware bags for each step.
  2. Attach Legs: Screw adjustable legs into pre-drilled holes on bottom panel (D). Do not fully tighten until leveling.
  3. Assemble Frame: Connect side panels (A, B) to bottom panel (D) using dowels and cam locks. Attach back panel (E) with screws.
  4. Install Top Panel: Place top panel (C) with sink cutout onto frame. Secure from inside with provided screws.
  5. Mount Hinges: Attach soft-closing hinges to door fronts (F) as per template. Then attach hinges to cabinet side panels.
  6. Install Drawer: Attach runners to cabinet sides. Assemble drawer box (if required) and attach front (G). Insert into runners.
  7. Adjust Doors/Drawers: Use hinge screws to align doors evenly. Adjust drawer front for level appearance.
  8. Final Check: Ensure all screws and cam locks are tight. Open/close doors and drawers to test smooth operation.

Tip: Leave protective film on surfaces until assembly is complete to prevent scratches.

Sink & Plumbing Installation

If sink bowl is included (check model):

  1. Prepare Seal: Apply supplied silicone sealant around underside edge of sink cutout on top panel.
  2. Place Sink: Lower sink bowl into cutout from above. Press down firmly to create watertight seal.
  3. Secure from Below: Underneath, attach mounting brackets with screws to clamp sink to countertop.
  4. Connect Plumbing: Install drain assembly and faucet according to their instructions. Connect water supply lines and P-trap.
  5. Test for Leaks: Turn on water slowly; check all connections. Tighten if any drips appear.

WARNING! Allow silicone sealant to cure fully (per product instructions, typically 24 hours) before using sink.

Adjustments & Leveling

Proper leveling ensures doors function correctly and prevents water pooling.

  1. Position Cabinet: Move cabinet to its final location against wall.
  2. Adjust Legs: Use a level on the top surface. Turn legs clockwise to raise, counterclockwise to lower until perfectly level side-to-side and front-to-back.
  3. Door Alignment: If doors sag or rub, open door and adjust hinge screws: horizontal screw for left/right movement, vertical screw for up/down movement.
  4. Drawer Alignment: Adjust drawer runner mounting screws to center drawer front within opening.
  5. Soft-Close Feature: Hinges and runners are pre-set. If doors/drawers close too hard or soft, some models have an adjustment screw on the hinge/runner mechanism.

Tip: For floors that are significantly uneven, consider using shims under legs before final tightening.

Care & Maintenance

To preserve the finish and functionality:

CAUTION! Never use steam cleaners on the cabinet.

Specifications

Warranty Information

IKEA limited warranty. Refer to the IKEA warranty booklet included with purchase or available at IKEA stores for full terms and duration. Covers material and manufacturing defects under normal household use. Warranty does not cover damage from improper assembly, accident, modification, or lack of maintenance. Proof of purchase (receipt) is required for warranty service.

Contact: For warranty claims, visit your local IKEA store or contact IKEA customer service at 1-800-434-4532 (IKEA-USA).

Troubleshooting

IssuePossible CauseSolution
Doors not closing smoothlyHinges misaligned or looseRe-adjust hinge screws as per section 7. Ensure cabinet is level.
Drawer sticking or wobblingRunners misaligned or not fully extendedCheck runner installation. Ensure both sides are level and securely fastened.
Cabinet wobblesLegs not adjusted properly; floor unevenRe-level cabinet using adjustable legs. Use shims if necessary.
Water leak under sinkFaulty seal or loose plumbingTighten drain connections. If seal is broken, reapply silicone sealant around sink rim.
Soft-close not workingMechanism obstructed or damagedCheck for debris in hinge/runner. Ensure it's properly engaged. May require part replacement.
Missing part or hardwarePackaging errorContact IKEA customer service with article number (104.971.70) and part description for replacement.

Note: For assembly help, visit the IKEA website and search for this product to view assembly video.

IKEA Customer Support: 1-800-434-4532 | www.ikea-usa.com

IKEA HEMNES 104.971.70 Sink Cabinet instructions manual © - All Rights Reserved 2025