IKEA HEKTAR 403.936.18 Floor Lamp instructions manual

The IKEA HEKTAR 403.936.18 is a modern floor lamp featuring a metal shade, adjustable height, on/off foot switch, and requires assembly. It uses an E27 bulb (max 13W LED or equivalent, not included). Designed for indoor use. Below are key sections for safety, features, assembly, installation, operation, care, and troubleshooting.

Features at a Glance

Key components: Metal shade, adjustable stand, stable base, integrated foot switch, E27 bulb socket.

Parts Included

Unpack and verify all parts before assembly.

1. Base (1 piece)
2. Adjustable pole sections (3 pieces)
3. Lamp shade (1 piece)
4. E27 bulb socket with cord (pre-assembled)
5. Hardware pack (screws, washers)
6. Allen key (included)

WARNING! Check for damaged parts. Do not use if any part is broken or missing.

Safety Instructions

Read all instructions before assembly and use.

1. Use only E27 bulb max 13W LED or equivalent. Higher wattage may cause fire.
2. Unplug lamp before assembly, cleaning, or bulb replacement.
3. Place on stable, level surface to prevent tipping.
4. Keep away from children, heat sources, and water.
5. Do not modify cord or use with damaged cord.

CAUTION! Risk of electric shock. Ensure power is off during assembly.

Assembly Instructions

Estimated assembly time: 15-20 minutes.

1. Attach base: Place base on floor. Insert bottom pole section into base and secure with provided screw using Allen key.
2. Connect pole sections: Screw middle pole section into bottom section. Repeat for top section.
3. Install socket: Thread cord through pole sections. Attach socket assembly to top of pole and secure.
4. Attach shade: Place metal shade over socket and secure with provided ring or screws.
5. Final check: Ensure all connections are tight and cord is not pinched.

Tip: Do not overtighten screws. Assemble on soft surface to avoid scratches.

Installation & Placement

• Place lamp on firm, flat surface away from walkways.
• Ensure cord is not a tripping hazard; use cord organizer if needed.
• Position for desired lighting effect - adjust height if applicable.
• Plug into standard 120V AC wall outlet.

WARNING! Do not place near curtains, bedding, or flammable materials.

Operation

Using the foot switch: Press once to turn on, press again to turn off.

Adjusting height: Loosen pole connection screws, adjust to desired height, retighten.

Lighting tips: Use as ambient or task lighting. Pair with compatible dimmable LED bulb for adjustable brightness (if bulb supports dimming).

Bulb Replacement

1. Unplug lamp and allow bulb to cool completely.
2. Remove shade if necessary (unscrew retaining ring).
3. Unscrew old bulb from E27 socket.
4. Screw in new E27 bulb (max 13W LED or equivalent).
5. Replace shade and plug in lamp.

CAUTION! Do not touch bulb with bare hands; use cloth. Ensure bulb is fully seated.

Care & Cleaning

Unplug before cleaning. Wipe with dry, soft cloth. For stubborn dirt, use damp cloth with mild soap, then dry immediately.

Do not: Use abrasive cleaners, solvents, or spray directly on lamp. Do not immerse in water.

Specifications

• Product Name: HEKTAR Floor Lamp
• Article Number: 403.936.18
• Height: Adjustable, approx. 140-160 cm (55-63 inches)
• Base Diameter: Approx. 30 cm (12 inches)
• Weight: Approx. 3.5 kg (7.7 lbs)
• Bulb: 1 x E27, max 13W LED or equivalent (not included)
• Voltage: 120V AC, 60Hz
• Cord Length: Approx. 180 cm (71 inches)
• Color: Black/Anthracite (as per model)

Troubleshooting

Disposal: Dispose of according to local regulations. Recycle materials where possible.

Warranty & Support: Refer to IKEA warranty card. For assistance, visit www.ikea.com or contact local IKEA store.