IKEA HAVSEN 192.537.28 Sink instructions manual

The IKEA HAVSEN 192.537.28 is a stainless steel double bowl kitchen sink designed for durability and functionality. It features a brushed satin finish, two equal-sized bowls, a standard 3.5-inch center drain hole configuration, pre-drilled holes for faucet and accessories, sound-absorbing undercoating, and is compatible with most standard kitchen cabinets (minimum 36-inch base cabinet recommended). Below are key sections for safety, features, installation, care, and warranty information.

1. Features at a Glance 2. Package Contents 3. Safety Instructions 4. Specifications 5. Tools Required 6. Installation Steps 7. Connecting Plumbing 8. Sealing and Finishing 9. Care & Cleaning 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: Stainless steel sink body, Sound-absorbing undercoating, Pre-cut drain holes, Mounting clips, Template for countertop cutout.

Feature	Description
Material	18-gauge stainless steel with brushed satin finish
Configuration	Double bowl, equal size
Dimensions	Overall: 33" x 22" (approx.)
Bowl Depth	8 inches (each bowl)
Drain Hole	Standard 3.5-inch center (pre-cut)
Faucet Holes	Pre-drilled for 1 or 3-hole faucet installation
Mounting Type	Undermount (primary) / Top-mount (optional with rim)
Sound Dampening	Integrated undercoating to reduce noise
Weight Capacity	Designed for standard kitchen use
Compatibility	Fits most 36-inch base cabinets

Package Contents

Unpack and verify all parts before starting installation.

HAVSEN sink unit (1 piece)
Mounting clips and screws (set)
Installation template (1 sheet)
User manual / instruction booklet
Warranty card

WARNING! Inspect for shipping damage before installation. Do not install if sink is dented or scratched.

Safety Instructions

Read all instructions before installation.

Wear safety glasses and gloves during installation.
Ensure countertop is level and cabinet is structurally sound.
Disconnect water supply before beginning work.
Use appropriate tools; avoid excessive force.
Keep work area clean and free of obstructions.

CAUTION! Stainless steel edges can be sharp. Handle with care.

Specifications

Model Number: HAVSEN 192.537.28
Material: 18-gauge stainless steel (AISI 304)
Finish: Brushed satin (non-reflective)
Overall Dimensions: 33" L x 22" W
Bowl Dimensions: Each bowl 15" L x 16" W x 8" D
Drain Hole Size: 3.5 inches (standard)
Weight: Approx. 25 lbs (11.3 kg)
Installation Type: Undermount (recommended)
Sound Dampening: Yes (undercoating applied)
Warranty: Limited 25-year warranty (see terms)

Tools Required

Gather these tools before starting installation.

Jigsaw or sink cutout tool
Drill with 1/4-inch drill bit
Screwdriver (Phillips and flathead)
Adjustable wrench
Silicone sealant (100% silicone, waterproof)
Measuring tape and pencil
Clamps (for template positioning)
Safety glasses and work gloves

Tip: Use a fine-tooth blade on jigsaw for clean cut edges.

Installation Steps

Follow these steps for proper undermount installation.

Prepare Cabinet: Ensure cabinet is empty, clean, and level.
Template Placement: Position template on countertop, center in cabinet opening. Clamp securely.
Mark Cutout: Trace template outline onto countertop with pencil.
Drill Starter Holes: Drill 1/4-inch holes at each inside corner of marked outline.
Cut Countertop: Use jigsaw to cut along marked line. Support cutout to prevent falling.
Test Fit: Place sink into cutout from below. Ensure proper fit and alignment.
Apply Sealant: Run bead of silicone sealant along top edge of sink flange.
Mount Sink: Insert sink into cutout. Secure with mounting clips from underneath.
Tighten Clips: Evenly tighten clips until sink is flush with countertop underside.
Clean Excess Sealant: Wipe away squeezed-out silicone with damp cloth.

WARNING! Allow silicone to cure 24 hours before connecting plumbing or using sink.

Connecting Plumbing

Connect drain and water supply lines after sink is mounted.

Install drain strainers and baskets into each bowl.
Connect P-trap and drain pipes according to local plumbing codes.
Attach water supply lines to faucet (if faucet not pre-installed).
Connect supply lines to shut-off valves; ensure no leaks.
Test drainage by pouring water into both bowls.

Tip: Use plumber's putty or silicone gasket for watertight drain connections.

Sealing and Finishing

Proper sealing prevents water damage.

Ensure all gaps between sink and countertop are filled with silicone.
Check mounting clip tightness (snug but not over-tightened).
Inspect underside for any leaks after first use.
Reapply sealant if gaps appear over time.

CAUTION! Do not use sink or apply weight until sealant fully cures (24 hours).

Care & Cleaning

Maintain appearance and longevity with proper care.

Daily Cleaning: Use mild dish soap, warm water, and soft cloth. Rinse and dry.
Stain Removal: For water spots or light stains, use vinegar solution (50/50 water/vinegar).
Scratch Prevention: Avoid abrasive cleaners, steel wool, or harsh chemicals.
Mineral Deposits: Remove with baking soda paste; rinse thoroughly.
Protect Finish: Do not leave wet sponges or metal objects in sink for extended periods.

CAUTION! Never use bleach or chlorine-based cleaners; they can damage stainless steel.

Warranty Information

IKEA Limited Warranty: 25-year limited warranty against defects in material and workmanship under normal household use. Warranty does not cover improper installation, accidental damage, misuse, or commercial use. Proof of purchase required. For warranty service, contact IKEA customer service with model number (192.537.28) and receipt.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Sink not draining	Clogged drain pipe	Clear obstruction; check P-trap for debris.
Water pooling under sink	Leaky connections or sealant failure	Tighten connections; reapply silicone sealant.
Sink vibrating or noisy	Loose mounting clips	Tighten mounting clips evenly.
Scratches on surface	Abrasive cleaning tools	Use soft cloths only; follow cleaning instructions.
Water spots/discoloration	Hard water minerals	Clean with vinegar solution; dry after each use.
Sink not level	Uneven cabinet or improper installation	Check cabinet level; adjust mounting clips.

Replacement Parts: Contact IKEA for mounting clip kits or drain parts.

Customer Service: 1-888-888-4532 (IKEA US) or visit www.ikea.com