IKEA GODMORGON 593.366.75 Sink Cabinet instructions manual

The IKEA GODMORGON 593.366.75 is a sink cabinet designed for bathroom installation, featuring a ceramic sink bowl, integrated storage cabinet with soft-closing doors and drawers, water-resistant finish, and pre-drilled holes for faucet and drain. Below are key sections for safety, parts list, assembly, installation, care, and warranty.

Parts & Hardware Included

Verify all parts before starting assembly. Contact IKEA if any parts are missing.

Safety Information

Read all instructions before assembly. Keep children and pets away during assembly.

1. Lifting: Cabinet is heavy; use two people to lift and position.
2. Stability: Must be securely attached to wall to prevent tipping.
3. Tools: Use correct tools to avoid injury and damage to parts.
4. Plumbing: Ensure water supply is turned off before connecting faucet and drain.
5. Electrical: Keep away from electrical outlets and wiring during installation.

WARNING! Failure to secure cabinet to wall can result in serious injury or death from tipping.

Tools Required

Not included with product. Gather before starting.

• Phillips screwdriver
• Adjustable wrench
• Level
• Pencil
• Drill with appropriate bits (for wall mounting)
• Wall anchors and screws (for wall type, not included)
• Silicone sealant (for sink sealing, not included)

Assembly Instructions

Assemble on a soft, clean surface to avoid scratches.

1. Attach feet: Screw adjustable feet into bottom corners of cabinet frame.
2. Install back panel: Align and secure with provided screws.
3. Mount drawer runners: Attach to inner sides of cabinet at marked positions.
4. Assemble drawer: Attach drawer front to drawer box, then install onto runners.
5. Install hinges: Attach soft-closing hinges to cabinet frame at marked positions.
6. Hang doors: Attach doors to hinges, adjust for alignment (fine-tuning later).
7. Check operation: Ensure doors and drawer open/close smoothly.

Tip: Do not fully tighten screws until all parts are aligned.

Installation to Wall

Cabinet must be anchored to wall studs or suitable solid backing.

1. Position cabinet in desired location, using level to ensure it is horizontal.
2. Mark drilling points through wall mounting brackets onto wall.
3. Drill pilot holes into wall studs or use appropriate wall anchors.
4. Lift cabinet and align with holes, then secure with screws through brackets.
5. Re-check level and adjust feet if necessary for stability.

CAUTION! Use appropriate fixings for your wall type (drywall, plaster, wood).

Sink & Plumbing Connection

Install sink bowl and connect plumbing after cabinet is secured to wall.

1. Place sink: Apply bead of silicone sealant around top edge of cabinet cutout.
2. Set sink bowl: Lower sink into cutout, press firmly to seal.
3. Connect drain: From below, attach drain assembly with gasket, tighten securely.
4. Install faucet: Insert faucet through pre-drilled hole, secure from below with mounting hardware.
5. Connect water lines: Attach hot/cold supply lines to faucet valves and water supply.
6. Test for leaks: Turn water supply on slowly, check all connections. Tighten if needed.

WARNING! Do not overtighten plastic fittings. Allow silicone to cure 24 hours before use.

Adjusting Doors & Drawers

Fine-tune for perfect alignment and smooth operation.

• Door height: Loosen hinge screws, adjust door up/down, retighten.
• Door depth: Use hinge adjustment screw to move door closer/further from frame.
• Drawer alignment: Adjust screws on runners to level drawer front.
• Soft-close: Hinges and runners are pre-set; no adjustment needed.

Tip: Make small adjustments and test frequently.

Care & Maintenance

Proper care ensures long-lasting appearance and function.

• Cleaning: Wipe surfaces with damp soft cloth and mild detergent. Dry immediately.
• Avoid: Abrasive cleaners, scouring pads, acetone, or bleach.
• Sink: Use non-abrasive cleaner for ceramic. Rinse thoroughly.
• Hardware: Periodically check hinge and runner screws for tightness.
• Water exposure: Wipe spills promptly. Although water-resistant, prolonged moisture should be avoided.

CAUTION! Never use steam cleaners on the cabinet.

Specifications

• Model: GODMORGON 593.366.75
• Color: White
• Material: Particleboard with foil, Ceramic sink
• Dimensions (W x D x H): 31.5" x 18.875" x 34.25" (80cm x 48cm x 87cm)
• Sink Bowl Dimensions: 16" x 14" (40.6cm x 35.6cm)
• Weight: 55 lbs (25 kg) unpacked
• Max Load Drawer: 22 lbs (10 kg)
• Faucet Hole: 1.25" (32mm) diameter, single hole
• Certification: Complies with ANSI/KCMA A161.1

Troubleshooting

Warranty & Support

IKEA limited warranty. See IKEA warranty booklet for full terms.

• Warranty Period: Varies by country; typically 10 years for cabinet, 1 year for fittings.
• Support: For missing parts, assembly help, or warranty claims:
• Visit: www.ikea.com
• Contact your local IKEA store.
• Use IKEA Assembly Service if available in your area.

Note: Warranty does not cover damage from improper assembly, installation, misuse, or lack of maintenance.