IKEA GODMORGON 593.043.92 High Cabinet instructions manual

The IKEA GODMORGON 593.043.92 is a high bathroom cabinet designed for storage above the toilet or in other bathroom spaces. It features a white finish, tempered glass door, adjustable shelves, soft-closing hinges, and water-resistant construction. Below are key sections for safety, assembly, installation, use, care, and troubleshooting.

Product Overview

Key features: High bathroom cabinet with tempered glass door, adjustable shelves, soft-closing mechanism, and wall-mounted design.

Safety Information

Read all instructions before assembly and installation.

1. Use two people for assembly and mounting to prevent injury.
2. Ensure wall is suitable for weight; use appropriate wall anchors.
3. Keep away from direct heat sources and excessive moisture.
4. Do not exceed maximum weight capacity of shelves.

WARNING! Cabinet is heavy; improper mounting can cause serious injury or damage. Secure to wall studs or solid masonry.

Included Parts

Check all parts before starting assembly.

• Cabinet frame (1 piece)
• Tempered glass door (1 piece)
• Adjustable shelves (2 pieces)
• Soft-closing hinges (2 pieces)
• Mounting brackets (2 pieces)
• Screws and wall plugs
• Assembly manual (this document)

CAUTION! If any parts are missing or damaged, contact IKEA customer service before proceeding.

Tools Required

• Phillips screwdriver or cordless drill with Phillips bit
• Level for ensuring cabinet is straight
• Pencil for marking wall
• Measuring tape
• Wall detector (recommended to find studs)
• Hammer (if using wall plugs)

Assembly Instructions

Follow steps in order; do not overtighten screws.

1. Lay cabinet frame on soft surface to avoid scratches.
2. Attach hinges to cabinet frame using provided screws.
3. Install door onto hinges; adjust alignment if necessary.
4. Insert adjustable shelves into desired positions.
5. Check that door opens and closes smoothly with soft-close feature.

Tip: Keep screws slightly loose until all parts are positioned, then tighten fully.

Wall Mounting

Cabinet must be securely mounted to wall.

1. Locate wall studs or use appropriate wall anchors for your wall type.
2. Mark drilling points using mounting brackets as template.
3. Drill holes and insert wall plugs if needed.
4. Attach mounting brackets to wall with screws.
5. Lift cabinet onto brackets; secure with provided screws.
6. Use level to ensure cabinet is straight before final tightening.

WARNING! Ensure mounting surface can support at least 4 times the weight of the loaded cabinet.

Adjusting Shelves

Shelves can be positioned at different heights.

1. Open door fully.
2. Lift shelf slightly and pull forward to remove.
3. Insert shelf pins at desired height in pre-drilled holes.
4. Place shelf on pins and push back until secure.
5. Test stability before loading items.

Note: Do not exceed 10 kg per shelf. Distribute weight evenly.

Care & Maintenance

Clean with damp cloth and mild detergent; dry immediately.

• Glass door: Use glass cleaner and soft cloth.
• Frame: Wipe with damp cloth; avoid abrasive cleaners.
• Hinges: Keep free of debris; lubricate if necessary with silicone spray.

CAUTION! Do not use harsh chemicals, ammonia-based cleaners, or abrasive pads on surfaces.

Troubleshooting

Warranty & Support

IKEA limited warranty applies. For assistance:

• Visit: www.ikea.com
• Contact: IKEA customer service at 1-888-888-4532
• Reference: Article number 593.043.92

Note: Keep receipt for warranty claims. DIY assembly may affect warranty if instructions not followed.