IKEA GLENN 301.356.58 Bar Stool instructions manual

The IKEA GLENN 301.356.58 is a modern bar stool featuring a sturdy steel frame, a comfortable seat, and a footrest. Designed for indoor use, it is easy to assemble with included tools and instructions. Below are key sections for safety, parts list, assembly steps, care instructions, and warranty information.

1. Parts & Tools Included 2. Safety Instructions 3. Assembly Steps 4. Care & Maintenance 5. Specifications 6. Troubleshooting 7. Warranty Information

Parts & Tools Included

All necessary components and tools for assembly are provided in the package.

Part NumberDescriptionQuantity
101Seat1
102Backrest1
103Leg Frame (Steel)1
104Footrest Bar1
105Allen Key1
106Screws (M6 x 25mm)8
107Plastic Caps8

Safety Instructions

Read all instructions before assembly and use.

  1. Assemble on a soft surface to avoid scratching parts.
  2. Ensure all screws are tightened securely.
  3. Do not exceed the maximum weight capacity of 250 lbs (113 kg).
  4. Keep away from direct heat sources and moisture.
  5. Use only for intended purpose (indoor seating).

WARNING! Do not stand on the stool or use as a ladder. Improper use may cause injury or damage.

Assembly Steps

Follow these steps in order for proper assembly.

  1. Attach Legs to Frame: Insert legs into frame slots and secure with provided screws (4 places).
  2. Install Footrest: Align footrest bar with pre-drilled holes on legs and fasten with screws (4 places).
  3. Attach Seat: Place seat onto frame and secure from underneath with remaining screws (4 places).
  4. Attach Backrest: Slide backrest into slots on seat and tighten screws (2 places).
  5. Final Check: Ensure all screws are tight and stool is stable. Cover screw heads with plastic caps.

Tip: Do not overtighten screws to avoid stripping threads.

Care & Maintenance

CAUTION! Do not use bleach, ammonia, or harsh chemicals. Keep away from excessive moisture.

Specifications

Troubleshooting

IssuePossible CauseSolution
Stool wobblesUneven floor or loose screwsTighten all screws; place on level surface.
Screws not fittingWrong screw or misaligned partsCheck part numbers and alignment; use correct screws.
Backrest looseScrews not tightenedSecure backrest screws firmly.
Scratches on frameAssembly on hard surfaceAssemble on carpet or soft mat.
Plastic caps not fittingScrew heads not fully seatedEnsure screws are flush, then press caps on.

Note: If parts are missing or damaged, contact IKEA customer service.

Warranty Information

This product is covered by IKEA's limited warranty. Refer to the IKEA warranty booklet for full terms and conditions.

Disclaimer: IKEA reserves the right to change specifications without prior notice.

IKEA GLENN 301.356.58 Bar Stool instructions manual © - All Rights Reserved 2025