IKEA FJÄLLBO 703.421.99 Shelf instructions manual

The IKEA FJÄLLBO 703.421.99 is a freestanding shelf unit with an industrial-inspired design featuring a black metal frame and dark stained veneer shelves. It provides open storage with a rustic, modern look. Below are key sections for safety, parts list, assembly instructions, care, and warranty information.

1. Parts & Hardware 2. Safety Instructions 3. Assembly Steps 4. Specifications 5. Placement & Stability 6. Care & Maintenance 7. Warranty Information 8. Troubleshooting

Parts & Hardware

All components included in the package.

Part NameQuantityDescription
Metal frame side2Black metal side panels with pre-drilled holes
Shelf board4Dark stained veneer shelves
Metal crossbar2Horizontal support bars
Screw A16Wood screws for attaching shelves
Screw B8Metal screws for frame assembly
Allen key1Included tool for assembly
Wall attachment device1 setFor securing shelf to wall
Instruction manual1This document

Safety Instructions

Read all instructions before assembly. Keep children and pets away during assembly.

  1. Assemble on a soft surface to avoid scratching parts.
  2. Use only the provided Allen key and screws.
  3. Ensure all screws are tightened securely.
  4. Always secure the shelf to the wall using the provided wall attachment device to prevent tipping.
  5. Do not exceed the maximum load capacity of 55 lbs (25 kg) per shelf.

WARNING! Serious or fatal crushing injuries can occur from furniture tipping over. Always secure this furniture to the wall using the provided restraints.

Assembly Steps

Estimated assembly time: 45-60 minutes. Two people recommended.

  1. Prepare: Unpack all parts and lay them on a clean, soft surface. Verify all parts against the parts list.
  2. Frame Assembly: Connect the two metal side frames using the two metal crossbars. Attach with Screw B (8 pieces) using the Allen key.
  3. Shelf Installation: Starting from the bottom, place the first shelf board onto the frame supports. Secure it from underneath using Screw A (4 per shelf). Repeat for all four shelves.
  4. Final Check: Ensure the unit is square and all screws are tight. Do not overtighten.
  5. Wall Attachment: Locate wall studs. Attach the provided anti-tip bracket to the wall, then secure the top rear of the shelf frame to the bracket.

CAUTION! Do not stand or sit on the shelves. The unit is for storage only.

Specifications

Placement & Stability

Place on a level, solid floor. Avoid placing near heat sources or in direct sunlight.

Wall Attachment is Mandatory: The provided wall attachment device must be used to secure the shelf to a wall stud. This prevents the unit from tipping over, especially if children might climb on it.

Load Distribution: Place heavier items on lower shelves. Distribute weight evenly. Do not overload.

Care & Maintenance

Clean with a damp cloth wrung out in a mild cleaner. Wipe dry immediately.

  1. Metal Frame: Wipe with a soft, dry cloth. For stubborn marks, use a damp cloth.
  2. Wood Shelves: Dust regularly. Clean with a cloth dampened with water and a mild detergent. Never use abrasive cleaners, scouring pads, or wax polish.
  3. Avoid prolonged exposure to direct sunlight and high humidity to prevent fading and warping.

CAUTION! Do not use harsh chemicals, abrasive cleaners, or steel wool on any surface.

Warranty Information

IKEA limited warranty. For details, refer to the IKEA warranty brochure included in the package or visit www.ikea.com.

This warranty covers material and manufacturing defects for the period specified in the IKEA warranty terms. The warranty does not cover damage caused by improper assembly, misuse, accidents, or lack of care.

Customer Service: For missing parts or assembly questions, contact IKEA customer support at 1-888-888-4532 or visit your local IKEA store.

Troubleshooting

ProblemPossible CauseSolution
Frame wobblesScrews not tight; floor unevenCheck and tighten all frame screws. Place on a level surface or use furniture shims under legs.
Shelf sagsWeight limit exceededRemove excess weight. Do not exceed 55 lbs per shelf. Distribute weight evenly.
Missing partPart not in boxContact IKEA customer service with article number (703.421.99) for replacement parts.
Difficulty assemblingParts misalignedDisassemble the step and ensure all holes align before inserting and tightening screws. Follow diagrams carefully.
Scratches on surfaceAssembly on hard surfaceAssemble on a carpet or blanket. Minor scratches on metal can be touched up with a black marker.

Re-tighten: Check screw tightness every few months as wood and metal may settle.

Support: www.ikea.com or 1-888-888-4532.

IKEA FJÄLLBO 703.421.99 Shelf instructions manual © - All Rights Reserved 2025