IKEA FALHOLMEN 192.178.58 Table instructions manual

The IKEA FALHOLMEN 192.178.58 is a versatile outdoor table designed for durability and easy assembly. Constructed from powder-coated steel and weather-resistant materials, it features a slatted tabletop for drainage, adjustable feet for stability on uneven surfaces, and a foldable design for convenient storage. Below are key sections for safety, parts list, assembly instructions, care, and warranty information.

1. Parts & Hardware Included 2. Tools Required 3. Safety Instructions 4. Assembly Steps 5. Adjusting & Leveling 6. Folding for Storage 7. Care & Maintenance 8. Specifications 9. Warranty Information 10. Troubleshooting

Parts & Hardware Included

Before assembly, verify all parts are present. Key components: Tabletop frame, Leg frames (4), Cross braces, Adjustable feet, Hardware pack.

Part Description	Quantity	Image Ref.
Tabletop frame (slatted)	1	A
Leg frame assembly	4	B
Cross brace (long)	2	C
Cross brace (short)	1	D
Adjustable foot with bolt	4	E
Hex key (Allen wrench)	1	F
Bolts M8 x 20mm	12	G
Washers 8mm	12	H

Tools Required

Only the included hex key is needed for assembly. For easier tightening, a cordless drill with hex bit adapter is optional.

Included hex key (Allen wrench).
Optional: Cordless drill with appropriate hex bit.
Clean, flat surface for assembly.

NOTE: Do not use power tools on high torque settings to avoid stripping threads.

Safety Instructions

Read all instructions before assembly. Ensure a safe working environment.

Assemble on a soft, clean surface to prevent scratching.
Keep small hardware away from children and pets.
Use two people for lifting and positioning the tabletop.
Ensure all bolts are fully tightened before use.
Check stability on uneven ground before placing items on table.

WARNING! Table is heavy; lift with proper technique to avoid back injury. Do not exceed maximum load capacity.

Assembly Steps

Follow steps in order. Estimated assembly time: 30-45 minutes.

Attach Legs to Tabletop: Place tabletop upside down on protected surface. Position one leg frame (B) at each corner. Insert bolts (G) with washers (H) through pre-drilled holes. Hand-tighten with hex key.
Install Cross Braces: Connect the two long cross braces (C) between the front and back leg pairs. Attach the short cross brace (D) in the center for added stability. Tighten all bolts securely.
Attach Adjustable Feet: Screw the adjustable feet (E) into the bottom of each leg. Do not fully tighten until leveling step.
Flip Table Upright: With assistance, carefully flip the assembled table right-side up.
Final Tightening: Go back and ensure every bolt and connection is fully tightened.

CAUTION! Do not stand or sit on the table during assembly or at any time.

Adjusting & Leveling

The adjustable feet allow for stability on patios, decks, or uneven ground.

Place table in its intended location.
Check for wobble by gently rocking the table.
Turn the adjustable foot at the wobbling corner clockwise to lower it or counterclockwise to raise it.
Repeat until the table is stable and does not rock.
Tighten the lock nut on each foot (if present) to secure the setting.

Tip: Use a spirit level on the tabletop for precise leveling.

Folding for Storage

Designed for convenient off-season storage.

Clear the tabletop of all items.
With two people, lift the table and place it on its side.
Release the locking pins or levers on the leg hinges (if applicable to your model).
Fold the legs inward toward the tabletop.
Secure the legs with the provided strap or bungee cord to keep them folded.
Store in a dry, covered area.

WARNING! Ensure locking mechanisms are fully engaged before unfolding and using the table again.

Care & Maintenance

Proper care extends the life of your outdoor table.

Cleaning: Wipe with a soft cloth dampened with mild soapy water. Rinse with clean water and dry thoroughly. Do not use abrasive cleaners or steel wool.
Rust Prevention: Although powder-coated, check for chips or scratches annually. Touch up with matching outdoor paint if necessary.
Winter Storage: Recommended to fold and store indoors or under a waterproof cover during harsh weather.
Slat Drainage: Keep the gaps between slats clear of debris to allow water drainage.

CAUTION! Do not use pressure washers as they can damage the coating and force water into joints.

Specifications

Model: FALHOLMEN 192.178.58
Dimensions (Assembled): Length: 59", Width: 35.5", Height: 29.5"
Dimensions (Folded): Approx. 59" x 35.5" x 6"
Tabletop Material: Steel, powder-coated
Frame Material: Steel, powder-coated
Weight Capacity: Max. load 110 lbs (evenly distributed)
Weight: 48 lbs
Color: Dark gray
Intended Use: Outdoor dining and entertaining

Warranty Information

IKEA Limited Warranty: This product is warranted against manufacturing defects in materials and workmanship for a period of 10 years for outdoor furniture, under normal residential use. Proof of purchase is required.

Coverage includes: Structural defects (frame, welds). Excludes: Normal wear and tear, damage from improper assembly, accident, misuse, commercial use, or lack of maintenance. For warranty service, contact IKEA customer service with your receipt and product information.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Table wobbles	Uneven ground, feet not adjusted	Adjust individual feet as per Leveling section. Ensure all leg bolts are tight.
Difficulty folding legs	Dirt in hinges, locking mechanism engaged	Clean hinge area. Check for and release any locking pin or lever.
Rust spots appearing	Scratched coating, prolonged moisture	Sand area lightly, clean, and apply touch-up paint. Keep dry when possible.
Bolt won't tighten	Cross-threaded, wrong bolt	Remove bolt, check threads. Ensure you are using the correct bolt (M8 x 20mm).
Tabletop sags	Exceeded weight limit, loose braces	Remove weight. Check and tighten all cross brace connections.

Missing Parts? Contact IKEA customer service for a replacement parts pack.

Support: Visit www.ikea.com or contact your local IKEA store.