IKEA ESSENTIELL 605.222.85 Dishwasher instructions manual

The IKEA ESSENTIELL 605.222.85 is a built-in dishwasher designed for efficiency and ease of use. It features multiple wash programs, adjustable racks, a salt and rinse aid system, child lock, delay start, and energy-saving modes. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Detergents and Additives 8. Care & Maintenance 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, Upper and lower spray arms, Cutlery basket, Filter system, Salt container, Rinse aid dispenser.

FeatureDescription
ProgramsAuto, Intensive, Eco, Quick, Glass, Rinse
Delay StartProgram start delay from 1 to 24 hours
Child LockLocks control panel to prevent accidental changes
Half LoadOption for washing only one rack to save water/energy
Water SoftenerIntegrated salt container for hard water areas
Rinse Aid IndicatorLED alerts when rinse aid needs refilling
Acoustic SignalCan be turned on/off to signal end of program
Energy ClassA++ for energy efficiency
Dimensions (HxWxD)81.5 x 59.8 x 55 cm
Place SettingsUp to 13 place settings

Installation

Unpack and inspect contents. Ensure installation space meets requirements.

  1. Position the dishwasher: Place in the prepared cabinet space under the countertop.
  2. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
  3. Connect drainage: Secure drain hose to sink drain or pipe (height 40-100 cm).
  4. Electrical connection: Plug into a grounded 220-240V, 50Hz socket.
  5. Level the appliance: Adjust feet to ensure the dishwasher is perfectly level.

WARNING! Installation must be performed by a qualified technician. Ensure water and electrical connections are secure to prevent leaks or hazards.

First-Time Setup

Before first use, prepare the dishwasher.

  1. Remove transport materials: Take out all interior packaging and securing brackets.
  2. Fill salt container: Unscrew cap, pour in water softener salt until full (first use only), then refill with salt.
  3. Fill rinse aid dispenser: Open compartment, pour rinse aid up to the MAX mark.
  4. Run an empty cycle: Select the Intensive program without dishes to clean the interior.
  5. Set water hardness: Use the program button combination to set according to local water hardness.

CAUTION! Only use dishwasher salt in the salt container. Do not use table salt.

Specifications

Controls and Settings

Control Panel: ON/OFF button, Program selector, Delay Start button, Half Load button, Child Lock button, Start/Pause button.

Program Selection: Turn the program selector to choose the desired wash cycle. The estimated time and temperature will display.

Delay Start: Press the Delay button, then use the program selector to set hours (1-24). Press Start to activate the timer.

Half Load: Press this button before starting to wash only the upper or lower rack (selectable via program selector).

Child Lock: Press and hold for 3 seconds to lock/unlock the control panel.

To Start a Cycle: Select program, close door firmly, press Start/Pause. The display will show remaining time.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

  1. Scrape off large food residues. Pre-rinsing is not necessary.
  2. Load lower rack: Place plates, pots, pans. Ensure items do not block the spray arm.
  3. Load upper rack: Place glasses, cups, bowls. Use the fold-down cup shelves.
  4. Cutlery basket: Place knives, forks, spoons with handles down for safety. Mix items to prevent nesting.
  5. Adjust upper rack height: Lift the rack by the sides to set in higher or lower position.
  6. Check rotation: Manually rotate the lower and upper spray arms to ensure they move freely.

Tip: Do not overload. Place delicate items in the upper rack. Refer to the loading diagram inside the door.

Using Detergents and Additives

Use only detergents and additives designed for dishwashers.

  1. Detergent: Fill the main detergent dispenser in the door. Use the amount recommended on the detergent packaging. For the Eco program, use a reduced amount.
  2. Rinse Aid: The dispenser is filled separately. Adjust the dosage setting (1-6) via the dial next to the dispenser; higher numbers release more rinse aid.
  3. Salt: The water softener salt is filled in the container at the bottom of the tub. Refill when the salt indicator light comes on.
  4. Combined Tablets: If using 3-in-1 or all-in-one tablets, place in the main detergent dispenser. Ensure the rinse aid dispenser is empty and set to the lowest setting.

WARNING! Do not mix different types of detergents. Keep all detergents out of reach of children.

Care & Maintenance

Regular maintenance ensures long life and performance.

  1. Clean the filters: Twist and lift out the coarse filter and microfilter assembly. Rinse under warm water. Reinsert correctly.
  2. Clean the spray arms: Check holes for blockages and rinse under water.
  3. Wipe door seals and interior: Use a damp cloth. Do not use abrasive cleaners.
  4. Exterior: Wipe with a soft, damp cloth. For stainless steel models, wipe in the direction of the grain.
  5. Run a maintenance cycle: Once a month, run an empty cycle with a dishwasher cleaner or a cup of vinegar placed on the upper rack.

CAUTION! Always disconnect from power before any maintenance. Never remove the filters while the dishwasher is operating.

Safety Information

Read all instructions before use.

Regulatory Information

This appliance complies with European Directives 2014/35/EU (Low Voltage), 2014/30/EU (EMC), and 2009/125/EC (Ecodesign). The declaration of conformity is available from the manufacturer. Disposal: At end of life, do not dispose with household waste. Take to an authorized collection point for recycling. For more information, contact your local authority. IKEA and ESSENTIELL are trademarks of Inter IKEA Systems B.V.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher does not startNo power, door not closed, child lock onCheck plug/power; close door firmly; deactivate child lock.
Water not enteringWater tap closed, inlet hose kinked, filter blockedOpen tap; straighten hose; clean inlet filter.
Water not drainingDrain hose kinked or blocked, filter cloggedCheck hose path; clean drain pump and filters.
Poor washing resultsSpray arms blocked, incorrect loading, old/dirty filters, low detergentClean spray arms; reload correctly; clean filters; use correct amount of fresh detergent.
Salt indicator light is onSalt container is emptyRefill with dishwasher salt.
Rinse aid indicator light is onRinse aid dispenser is emptyRefill with rinse aid.
Unusual noiseSpray arm hitting dishes, foreign object in pumpRearrange load; check for and remove foreign objects.
Error code on display (e.g., E1, E2)Various faults (water supply, drainage, sensor)Consult the full error code list in the manual. Turn appliance off and on. If persists, call service.

Reset: Turn the dishwasher off at the mains for 1 minute, then back on.

Service: For IKEA warranty service, contact your local IKEA store or visit www.ikea.com.

IKEA ESSENTIELL 605.222.85 Dishwasher instructions manual © - All Rights Reserved 2025