IKEA ENHET 094.721.61 Door instructions manual

The IKEA ENHET 094.721.61 is a door designed for the ENHET kitchen cabinet series, featuring a clean, modern design with a white finish. It is made from particleboard with a foil finish, is easy to install and clean, and is compatible with various ENHET frames and hinges. Below are key sections for safety, features, parts included, installation, adjustment, care, and warranty information.

Features at a Glance

Key components: Door panel, pre-drilled holes for hinges, white foil finish.

Parts Included

Check that you have all parts before starting installation.

• 1 x Door panel (ENHET 094.721.61)
• 1 x Instruction manual (this document)
• Note: Hinges and screws are sold separately (see ENHET hinge package).

Tools Required

You will need the following tools for installation:

1. Phillips screwdriver (size #2)
2. Measuring tape
3. Pencil
4. Level (optional, for alignment check)

Specifications

• Article Number: 094.721.61
• Width: 40 cm
• Height: 60 cm
• Thickness: 1.6 cm
• Weight: 2.5 kg
• Finish: White foil
• Material: Particleboard, foil
• Hinge Type: Compatible with ENHET concealed hinges (sold separately)

Installation Instructions

Follow these steps to attach the door to your ENHET cabinet frame.

1. Prepare the frame: Ensure the cabinet frame is securely mounted to the wall or base.
2. Attach hinges: Install the ENHET hinges onto the cabinet frame according to the hinge instructions.
3. Align door: Hold the door against the frame, aligning the pre-drilled holes with the hinge plates.
4. Secure door: Insert the screws through the hinge plates into the door holes and tighten with a screwdriver.
5. Check alignment: Open and close the door to ensure it moves smoothly and sits flush with the frame.

WARNING! Ensure the cabinet frame is stable and securely fixed before attaching the door to prevent tipping or injury.

Door Adjustment

If the door is not aligned properly, adjust the hinges.

1. Vertical adjustment: Loosen the screw on the hinge plate slightly, move the door up or down, then retighten.
2. Horizontal adjustment: Use the adjustment screw on the hinge to move the door left or right.
3. Depth adjustment: Turn the depth adjustment screw to bring the door closer to or further from the frame.
4. Final check: Ensure the door closes evenly and there are no gaps.

Care & Cleaning

To maintain the appearance of your ENHET door:

1. Use a soft, damp cloth with mild soapy water.
2. Wipe gently; do not scrub.
3. Dry immediately with a clean, dry cloth.
4. Avoid abrasive cleaners, scouring pads, or harsh chemicals.

CAUTION! Do not allow water to seep into the edges of the door, as this can cause swelling.

Safety Information

• This door is intended for indoor use only.
• Do not overload the door or use it as a step or support.
• Keep away from direct heat sources (ovens, radiators) to prevent warping.
• Ensure all screws are tightened securely to prevent the door from detaching.
• Keep small children away from installation area.

Warranty & Support

IKEA limited warranty applies. For product support or spare parts:

• Visit the IKEA website: www.ikea.com
• Contact IKEA customer service: 1-888-888-4532
• Refer to article number 094.721.61

Note: Warranty does not cover damage from improper installation, misuse, or lack of maintenance.

Troubleshooting

Replacement: For damaged doors, contact IKEA for replacement parts.

Service: 1-888-888-4532; www.ikea.com