IKEA EKENÄSET 305.334.93 Armchair instructions manual

The IKEA EKENÄSET 305.334.93 is a modern armchair featuring a sturdy wooden frame, removable and washable cover, high resilience foam for comfort, and a simple assembly design. Below are key sections for safety, parts list, assembly instructions, care, and warranty information.

1. Parts & Tools Included 2. Safety Instructions 3. Assembly Steps 4. Care & Maintenance 5. Specifications 6. Troubleshooting 7. Warranty & Support

Parts & Tools Included

All necessary components for assembly are included in the package. Please verify before starting.

Part NumberDescriptionQuantity
100001Armchair frame (left side)1
100002Armchair frame (right side)1
100003Backrest panel1
100004Seat panel1
100005Armrest covers (pair)1 set
100006Removable fabric cover1
100007Allen key (6mm)1
100008Screws (M8 x 50mm)8
100009Wooden dowels4
100010Plastic covers (for screw holes)8

Safety Instructions

Read all instructions before assembly. Ensure a clean, spacious work area.

  1. Assembly requires two people. Do not attempt alone.
  2. Keep small parts away from children and pets to avoid choking hazards.
  3. Use only the provided tools and hardware. Do not overtighten screws.
  4. Inspect all parts for damage before assembly. Do not use damaged components.
  5. Place the assembled armchair on a flat, stable surface. Do not place near direct heat sources.

WARNING! The wooden frame is heavy; lift with care to avoid back injury or damage to parts.

Assembly Steps

Follow these steps in order for correct assembly. Estimated time: 30-45 minutes.

  1. Prepare: Unpack all parts and lay them on a soft surface to prevent scratches.
  2. Attach Backrest: Align the backrest panel (100003) with the left and right frame sides (100001, 100002). Insert wooden dowels into pre-drilled holes.
  3. Secure Frame: Using the Allen key, tighten the M8 screws through the frame into the backrest. Do not fully tighten until all screws are placed.
  4. Install Seat Panel: Place the seat panel (100004) onto the frame base. Secure with remaining screws from underneath.
  5. Attach Armrest Covers: Slide the armrest covers (100005) over the wooden armrests until they click into place.
  6. Final Tightening: Ensure all screws are fully tightened. Cover screw holes with the provided plastic caps (100010).
  7. Apply Fabric Cover: Stretch the removable fabric cover (100006) over the assembled frame, ensuring it fits snugly into all seams.

Tip: If parts do not align easily, check that dowels are fully inserted and panels are oriented correctly (marked L/R).

Care & Maintenance

Proper care will extend the life and appearance of your armchair.

CAUTION! Never soak the wooden frame. Do not use steam cleaners on the fabric.

Specifications

Troubleshooting

SymptomPossible CauseCorrective Action
Frame feels wobblyScrews not fully tightenedCheck and tighten all screws with the Allen key. Ensure dowels are fully inserted.
Fabric cover does not fitCover not stretched properly or frame misalignedRemove cover, check frame assembly for correct alignment, reapply cover starting from the back.
Squeaking noise when sittingWood rubbing against wood or loose jointIdentify the squeaking joint, loosen screws slightly, apply a small amount of furniture wax or felt pad, then retighten.
Armrest cover slides offNot fully pushed onRemove and realign, then push firmly until an audible click is heard.
Missing partPart left in packaging or not includedCheck all packaging material thoroughly. Contact IKEA customer support with your product and batch number.

Warranty & Support

This IKEA product is covered by a limited warranty. Refer to the IKEA warranty terms included in the "IKEA Family" booklet or on the IKEA website.

Note: Keep your receipt as proof of purchase. Warranty does not cover damage from improper assembly, accidents, modification, or commercial use.

IKEA EKENÄSET 305.334.93 Armchair instructions manual © - All Rights Reserved 2025