IKEA EBBEMÅLA 905.183.38 Floor Lamp instructions manual

The IKEA EBBEMÅLA 905.183.38 is a modern floor lamp designed for ambient lighting. It features a metal base and stem with a fabric shade, an integrated on/off foot switch, and uses a single E27 bulb (max 15W LED or equivalent, not included). Below are key sections for safety, assembly, operation, care, and troubleshooting.

1. Safety Information 2. Parts Included 3. Assembly Instructions 4. Specifications 5. Operation 6. Care & Maintenance 7. Troubleshooting 8. Warranty & Support

Safety Information

Read all instructions before assembly and use.

Warning	Description
Electrical Safety	Use only with recommended bulb type and wattage. Do not exceed 15W LED or equivalent.
Placement	Place on a stable, level surface away from heat sources and flammable materials.
Children	Keep out of reach of young children. Not a toy.
Maintenance	Always unplug lamp before cleaning, replacing bulb, or performing any maintenance.
Cord Safety	Do not run cord under carpets or furniture. Do not pinch or damage cord.

Parts Included

Check that all parts are present before starting assembly.

Base (Metal)
Stem (Metal, 2 sections)
Shade (Fabric)
Shade Ring (Metal)
Socket with pre-attached cord and foot switch
Hardware pack (Screws, washers)
Instruction manual (this sheet)

NOTE: Light bulb is not included.

Assembly Instructions

Estimated assembly time: 15-20 minutes. Tools required: Phillips screwdriver (not included).

Attach Base to Lower Stem: Insert the lower stem into the base. Secure with the provided screw and washer. Tighten firmly.
Connect Upper Stem: Screw the upper stem onto the lower stem by hand until snug.
Install Socket: Feed the cord through the center of the assembled stem. Attach the socket unit to the top of the upper stem using the provided locking ring. Hand-tighten.
Attach Shade: Place the fabric shade over the socket. Secure it by sliding the metal shade ring over the top of the shade and screwing it onto the socket threads.
Install Bulb: Screw an E27 bulb (max 15W LED or equivalent) into the socket. Do not overtighten.
Final Check: Ensure all connections are tight and the lamp stands upright without wobbling. Plug the cord into a wall outlet.

CAUTION! Do not plug in or turn on the lamp until assembly is complete and a bulb is installed.

Specifications

Product Name: EBBEMÅLA
Article Number: 905.183.38
Material: Base/Stem: Steel, epoxy/polyester powder coating. Shade: Polyester.
Bulb: 1 x E27 socket. Max 15W LED or equivalent (not included).
Switch: Integrated foot switch on cord.
Cord Length: Approx. 1.8 meters (6 feet).
Dimensions: Height: 140 cm. Base diameter: 25 cm.
Weight: 2.5 kg.

Operation

Plug the lamp into a standard 120V AC wall outlet.

To Turn On: Press the foot switch on the cord with your foot until you hear a click. The light should illuminate.
To Turn Off: Press the foot switch again until it clicks off.
Adjustment: The lamp is not adjustable. For best light distribution, place in a corner or beside furniture.

Tip: For ambient lighting, use a warm white LED bulb (2700K).

Care & Maintenance

Cleaning: Always unplug the lamp first.

Base & Stem: Wipe with a soft, dry cloth. For stubborn marks, use a slightly damp cloth. Do not use abrasive cleaners.
Fabric Shade: Use a vacuum cleaner with a soft brush attachment to remove dust. Do not wash or immerse in water.

Bulb Replacement: Unplug lamp. Allow old bulb to cool completely. Unscrew old bulb and screw in a new E27 bulb (max 15W LED).

CAUTION! Never touch the bulb with bare hands when it is hot.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Lamp does not turn on	Not plugged in; faulty bulb; foot switch issue	Ensure plug is in outlet. Try a known-working bulb. Check foot switch for clicks.
Lamp flickers	Loose bulb; poor socket contact	Turn off and unplug. Ensure bulb is screwed in tightly. If problem persists, try another bulb.
Lamp wobbles	Assembly not tight; uneven floor	Check and tighten all stem and base connections. Place on a level surface.
Overheating	Bulb wattage too high	Immediately unplug. Use only a bulb with 15W LED or lower equivalent wattage.

Warranty & Support

This IKEA product is guaranteed under the terms of the IKEA commercial warranty. For detailed warranty information, please visit www.ikea.com or contact your local IKEA store.

Customer Support: Visit the IKEA website for assembly help, spare parts, or to contact customer service.

Disposal: At end of life, dispose of according to local regulations for electronic waste (WEEE).