IKEA BJÖRKSNÄS 504.920.38 5 Drawer Chest instructions manual

The IKEA BJÖRKSNÄS 504.920.38 is a 5-drawer chest constructed from solid birch wood and birch veneer, featuring a natural finish, metal drawer runners, and a classic Scandinavian design. Below are key sections for safety, parts list, assembly instructions, care, and warranty information.

1. Parts & Hardware 2. Safety Instructions 3. Assembly Steps 4. Product Specifications 5. Drawer Installation & Adjustment 6. Care & Maintenance 7. Stability & Securing 8. Troubleshooting 9. Warranty & Support

Parts & Hardware

Before assembly, verify all parts are present. Key components: Solid birch wood panels, birch veneer drawer fronts, metal drawer runners, screws, dowels, cam locks.

Part Number	Description	Quantity
A1	Side panel (left)	1
A2	Side panel (right)	1
B	Back panel	1
C1-C5	Drawer fronts	5
D1-D5	Drawer bottoms	5
E	Top panel	1
F	Base plinth	1
PKT 1	Screw pack (various sizes)	1 set
PKT 2	Cam locks & dowels	1 set
PKT 3	Drawer runner set	5 pairs

Safety Instructions

Read all instructions before assembly. Use proper tools.

Assemble on a soft, clean surface to avoid scratches.
Use included Allen key; do not overtighten screws.
Ensure chest is stable before loading drawers.
Do not allow children to climb or play on furniture.

WARNING! Heavy furniture can tip over. Secure to wall using provided wall attachment device to prevent serious or fatal tip-over accidents.

Assembly Steps

Follow steps in numerical order. Estimated assembly time: 60-90 minutes.

Frame Assembly: Connect side panels (A1, A2) to back panel (B) using dowels and cam locks. Tighten cams clockwise.
Base Attachment: Attach base plinth (F) to bottom of frame using screws from PKT 1.
Top Panel: Place top panel (E) onto frame. Secure from inside using screws.
Drawer Runner Installation: Attach metal runners to inner sides of frame as per markings. Ensure they are level and aligned.
Drawer Box Assembly: For each drawer, connect sides to front/back pieces, then insert drawer bottom (D). Attach front panel (C) to drawer box.
Final Installation: Slide drawers into runners. Test smooth operation.

CAUTION! Two people recommended for lifting top panel and final positioning.

Product Specifications

Product Name: BJÖRKSNÄS
Article Number: 504.920.38
Material: Solid birch, Birch veneer, Fiberboard, Plastic, Steel
Finish: Clear acrylic lacquer
Dimensions (W x H x D): 35 3/8 x 47 1/4 x 19 5/8 inches (90 x 120 x 50 cm)
Drawer Dimensions (approx.): 32 5/8 x 8 1/4 x 17 3/4 inches (83 x 21 x 45 cm)
Max Load per Drawer: 22 lbs (10 kg)
Weight: 77 lbs (35 kg)
Designer: IKEA of Sweden

Drawer Installation & Adjustment

Drawers use full-extension metal runners for smooth operation.

Align drawer with installed runners.
Push drawer in until it clicks into place.
To remove: Pull drawer fully out, press release tabs on both sides of runner, and lift drawer out.
Adjustment: If drawer is uneven, loosen screws on runner bracket slightly, adjust drawer front alignment, then retighten.

Tip: Apply a small amount of furniture wax or paraffin to runners if movement becomes stiff.

Care & Maintenance

Clean with a damp cloth wrung out in mild soapy water. Wipe dry immediately.

Wood Care: Avoid prolonged exposure to direct sunlight, heat sources, or high humidity.
Scratches: Minor scratches can be touched up with a matching wood stain marker.
Do Not Use: Abrasive cleaners, scouring pads, or silicone-based polishes.

CAUTION! Never use harsh chemicals; they may damage the lacquer finish.

Stability & Securing

CRITICAL: Tip-over of furniture can cause death or serious injury. Always secure this chest to the wall.

Locate the wall attachment device included in the hardware pack.
Position chest in its final location against a solid wall.
Attach the bracket to the back panel of the chest using provided screws.
Mark drill holes on wall through bracket. Drill into wall stud if possible.
Secure bracket to wall with appropriate wall anchors/screws (not always included).
Check stability by gently pulling top front edge.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Drawer sticks or is hard to open	Misaligned runners, overloaded	Realign runners; reduce drawer load; clean runners.
Frame feels wobbly	Cam locks not fully tightened, missing screws	Check and tighten all cam locks and frame screws.
Gap between drawer fronts	Drawers misaligned	Loosen front attachment screws, adjust alignment, retighten.
Missing part	Packaging error	Contact IKEA customer service with article number for replacement.
Scratches on wood surface	Assembly damage	Use touch-up pen (sold separately) or request spare part.

Warranty & Support

IKEA limited warranty applies. Refer to IKEA terms and conditions of warranty for your country.

Warranty Period: Varies by market, typically 10 years for frame, 1-2 years for moving parts.
Support: For missing parts, assembly help, or product issues:
Visit: www.ikea.com
Contact your local IKEA store.
Use the IKEA app for assembly instructions (search by article number 504.920.38).

Recycling: Dispose of packaging responsibly. Furniture can be recycled at IKEA take-back stations in many stores.